2. motepro
  3. Digi-Code Coding
Digi-Code Coding

motepro Digi-Code Coding Operating instructions

  • I have reviewed the provided instructions for the Multi-Code and Digi-Code remotes. This document outlines the process for coding the remotes including switch configuration copying procedures and battery safety measures. I'm ready to assist with any specific questions you may have regarding these remotes or the instructions provided.
  • How to set switch when coding Multi-Code to Multi-Code?
    How to set switch when coding Multi-Code to Digi-Code?
    What to do when no working remote is available?
Digi-Code Coding Instruc�ons
Both Digi-Code and Mu-Code are electronically the same.
MULTI-CODE Switches: UP for ON
DIGI-CODE Switches: DOWN for ON
1. Open both the working original remote and the new remote to reveal
two x 10 switch banks (L/H Bank = L/H Buon the circuit board or
one bank of 10 switches for a single buon remote.
2. Copy the switches exactly when coding Mu-Code to Mu-Code or
upside down when coding Mu-Code to Digi-Code.
If no working remote is available look to the receivers on the motor/s (these
are generally grey rectangular boxes aached to the motor.
Remove the inspecon panels to reveal the 10 switches. This will mainly be a
Mu-code receiver. Follow the steps above once you have located the
switches on the receiver.
www.remotepro.com.au
/