2. Hunter Industries
  3. ST-IBS-1600
ST-IBS-1600

Hunter Industries ST-IBS-1600 Installation guide

  • Hello! I've reviewed the provided user manual for the Hunter ST IBS-1600 Infill Barrier System. This document explains the step-by-step installation process, including how to properly fit the ring, cup, and other components. I'm ready to assist you with any questions you have about the system or the manual's contents.
  • Is it necessary to apply adhesive when installing the rotor?
    How do I install the ring of the rotor flange?
    What do I do after all retaining segments have been positioned under the rotor's flange?
    How do I install the cup over the rotor's green logo cap?
INFILL BARRIER SYSTEM
INSTALLATION GUIDE FOR THE ST-IBS-1600
1. To install the ring of the rotor
ange, use your ngers to pull and
place each retaining segment of the
ring under the ange.
2. Aer all retaining segments have
been positioned, check to make
sure they are completely under the
rotor’s ange.
3. To install the cup over the rotor’s
green logo cap, li the logo cap and
insert a piece of wood underneath.
5. Use your ngers to pull and place
each retaining segment of the cup
under the logo cap’s outer edge.
hunterindustries.com
4. Place the cup over the edge of the
logo cap.
NOTE
Do not apply adhesive to the
Hunter ST Inll Barrier System
when installing the rotor. All
parts must remain removable to
allow for rotor servicing.
HUNTER INDUSTRIES | Built on Innovation®
1940 Diamond Street, San Marcos, CA 92078 USA
hunterindustries.com
RC-137 IG EM 10/22
© 2022 Hunter Industries™. Hunter, the Hunter logo, and all other trademarks are property of Hunter Industries, registered in the U.S. and other countries.
ST-IBS-1600 Installation Guide
7. Carefully lower the logo cap and
cup assembly. Take care not to
disengage the cup from the logo
cap. Make sure the cup and ring are
aligned.
Fit and Finish
Aer installation for non-inll type material or to create a smoother transition to the playing eld, follow these additional steps.
1. Use a sharp blade or shears to trim/remove the inll barrier vertical walls.
2. Cut a round 36.5 cm diameter piece of the synthetic material being used for the project.
3. Use a Hunter-approved adhesive (ST-ADH-K) to attach it to the Inll Barrier System.
6. Aer all retaining segments have
been positioned, recheck to make
sure they are completely under the
logo cap.
https://hunter.help/st1600
SCAN
for help
/