4/8
4、Learn how to shut down operation of device and all control components quickley, never allow untrained
personnel to operate equipment.
5、Do not put combustible materials (such as gasoline, lighters and other equipment) are placed next to moving
equipment. To add fuel in a well ventilated place, stop running before refueling engine, gasoline is highly
flammable and would explode under certain conditions.
6、Do not overfill fuel tank, fuel filler neck should not have fuel. If fuel overflows, etc. shall be removed and
waiting for evaporate before starting engine.
7、where engine or fuel to increase fuel storage. No smoking or open flames.
8、Engine exhaust including carbon monoxide, avoid inhalation, and never operate machine in a closed,
unventilated poorly ventilated areas.
9、when engine is running, muffler will be very hot and heat will be continued a period of time after stopping, do
not touch it, to avoid burns or fire, allow to cool down engine, then move it or store it into room
Four. Device Control
1、Fuel value
Fuel valve is for controlling passage between fuel tank and carburetor when engine is running, fuel valve
must be pulled to ON position. When engine is not used, pull fuel valve to OFF position. Prevent oil outflow in
carburetor, reducing possibility of leakage of gasoline.
2、Engine ON/OFF
Engine switch controls ignition system, put engine switch to open position, start engine, put engine switch to
OFF position, shut down engine.
3、Choke lever
Choke rod control carburetor lever. When choke lever is located OFF position, improve concentration of
gasoline to cold start engine. After engine is started, choke lever located at open position, to provide suitable fuel
for its operation, but also for starting engine heat engine provides right fuel.
4、Throttle lever
Throttle lever controls engine speed, put throttle lever in desired engine speed position.
Five.Run
(One) Checking before running
1、Check engine, hydraulic tank and look and bottom of tubing ,to see if oil spill.
2、Wipe off excess dirt and other obstacles, especially around muffler and recoil starter
3、Check appearance , if all nuts, bolts and screws are strong, whether drive belt and chain is too loose ?.
4、Check engine and hydraulic oil tank level, low fuel runs may result engine damage, unsteady gait, periodic
replacement of engine oil and hydraulic oil, to avoid damage due to an accident, check the oil level before
starting.
