CONTACTLESS
SOAP DISPENSER
USER MANUAL
PLEASE NOTE:
Do not us the dispenser in a dishwasher.
Do not clean the dispenser with strong chemical agents.
Do not clean the dispenser with abrasive products.
WARRANTY
1-Year Limited Manufacturer’s Warranty
Your Colston product is backed by a one-year limited manufacturer’s warranty. For a period
of one year following date of purchase, Colston will repair or replace your product should it
fail due to a manufacturer’s defect (subject to certain limitations such as, but not limited
to, use of the product as directed or performing the intended function during which the
product may become damaged).
This one-year limited warranty does not cover any damage that results from unauthorized
or improper use, service, or repair. Further, it does not cover damage caused by accident,
negligence, purposeful harm, or normal wear and tear. Should you discover your Colston
product is not functioning properly, please send your product to our repair center for
evaluation, at the address listed below. If your product cannot be repaired or serviced, we
reserve the right to exchange it for a similar or newer model.
Please note that a at processing fee of $35.00 will be charged to cover the service
evaluation and return shipping of your product. All limited warranty claims must be
accompanied by a copy of your proof of purchase from an authorized retailer. Please send
your product, proof of purchase, and a check or money order in the amount of $35.00 made
out to Colston to:
Address:
Colston Appliances
3069 Taft Street
Hollywood, FL 33021
Contact:
warranty@colstonappliances.com
By purchasing this product and/or utilizing this limited warranty, you expressly waive the
right to be a member of or the lead plainti in any class action or any group civil action
against the manufacturer and agree that any dispute involving Colston shall be resolved in
Broward County, Florida as the exclusive jurisdiction in any court case and/or proceeding.
Prior to use, read these carefully and follow them to prevent personal injury. Retain the
manual for future reference.
PRODUCT INTRODUCTION
OPERATING INSTRUCTIONS
• Lift the dispenser cover to reveal the batteries chamber.
• Remove battery cover and insert 4 AAA type batteries.
• Follow the polarity markings located next to the batteries chamber.
• Place battery cover back on and ensure the dispenser cover is secured in place
FILLING THE DISPENSER
Slowly lift the removable top dispenser cover to reveal the soap compartment. When lling,
carefully pour the liquid soap into the soap compartment until it is approximately ¾ full.
Place the dispenser cover rmly back on. Do not hold the dispenser at an extreme angle
when it contains liquid. To properly use dispenser and avoid spills make sure to place it on a
stable, at surface.
SETTING THE DISPENSING TIME
Press the PLUS (+) or MINUS (-) buttons briey to change the length of time soap ows the
dispenser.
1. Mode 1: Press the PLUS (+) button once. The blue indicator light will ash once. The
dispensing time will be set to the lowest setting with the least amount of soap.
2. Mode 2: Press the PLUS (+) button a second time. The blue indicator light will ash twice.
The soap dispensing time will be set for approximately 0.9 seconds.
3. Mode 3: Press the PLUS (+) button a third time. The blue indicator light will ash three
times. The soap dispensing time will be set for approximately 1.3 seconds.
4. Mode 4: Press the PLUS(+) button a fourth time. The blue indicator light will ash four
time. The soap dispensing time will be set for approximately 1.6 seconds.
Pressing the MINUS(-) button will reverse the MODE sequence. Each press of the MINUS(-)
button will take the dispenser back one mode from its current position.
USING THE DISPENSER
To operate the dispenser, simply place your hand approximately 1”-2” inches (3-5cm) under
the sensor and the nozzle will dispense the desired amount of soap.
CLEANING AND MAINTENANCE
Clean the dispenser from outside with clean, humid and delicate cloth. Clean the inside of
the dispenser warm water at a temperature of max 122° F (50° C). If you use warm water
the coating inside the soap compartment may melt and the dispenser may permanently be
damaged.
DETAILS FOR CLEANING INSTRUCTIONS
1. Fill the soap compartment with warm water up to approximately ¾ full of the
dispenser capacity.
2. Make sure that the batteries’ chamber is empty and tightly closed. Next, close place
the dispenser’s cover nack on making sure it is secured in place and lightly shake while
holding the dispenser’s cover with you your ngers.
3. Pour out residual soap by tilting the dispenser with the soap compartment opening
directed downwards. See image below:
4. If necessary, repeat all the above-mentioned activities.
5. NEVER POUR OUT SOAP OR RESIDUAL SOAP WITH THE SOAP COMPARTMENT OPENING
DIRECTED UPWARDS. This can cause the risk of ooding the batteries chamber and
permanent damage of the dispenser.
1 Dispenser Cover
2 Soap Compartment
3 Batteries Chamber
4 Feeder
5 Soap Outlet
6 Motion Sensor
7 Plus(+) / Minus(-) Buttons For Mode Adjustment
8 Dispenser’s Body
9 Dispenser’s Base
/
