Prior to use, read these carefully and follow them to prevent personal injury. Retain the
manual for future reference.
PRODUCT INTRODUCTION
OPERATING INSTRUCTIONS
• Lift the dispenser cover to reveal the batteries chamber.
• Remove battery cover and insert 4 AAA type batteries.
• Follow the polarity markings located next to the batteries chamber.
• Place battery cover back on and ensure the dispenser cover is secured in place
FILLING THE DISPENSER
Slowly lift the removable top dispenser cover to reveal the soap compartment. When lling,
carefully pour the liquid soap into the soap compartment until it is approximately ¾ full.
Place the dispenser cover rmly back on. Do not hold the dispenser at an extreme angle
when it contains liquid. To properly use dispenser and avoid spills make sure to place it on a
stable, at surface.
SETTING THE DISPENSING TIME
Press the PLUS (+) or MINUS (-) buttons briey to change the length of time soap ows the
dispenser.
1. Mode 1: Press the PLUS (+) button once. The blue indicator light will ash once. The
dispensing time will be set to the lowest setting with the least amount of soap.
2. Mode 2: Press the PLUS (+) button a second time. The blue indicator light will ash twice.
The soap dispensing time will be set for approximately 0.9 seconds.
3. Mode 3: Press the PLUS (+) button a third time. The blue indicator light will ash three
times. The soap dispensing time will be set for approximately 1.3 seconds.
4. Mode 4: Press the PLUS(+) button a fourth time. The blue indicator light will ash four
time. The soap dispensing time will be set for approximately 1.6 seconds.
Pressing the MINUS(-) button will reverse the MODE sequence. Each press of the MINUS(-)
button will take the dispenser back one mode from its current position.
USING THE DISPENSER
To operate the dispenser, simply place your hand approximately 1”-2” inches (3-5cm) under
the sensor and the nozzle will dispense the desired amount of soap.
CLEANING AND MAINTENANCE
Clean the dispenser from outside with clean, humid and delicate cloth. Clean the inside of
the dispenser warm water at a temperature of max 122° F (50° C). If you use warm water
the coating inside the soap compartment may melt and the dispenser may permanently be
damaged.
DETAILS FOR CLEANING INSTRUCTIONS
1. Fill the soap compartment with warm water up to approximately ¾ full of the
dispenser capacity.
2. Make sure that the batteries’ chamber is empty and tightly closed. Next, close place
the dispenser’s cover nack on making sure it is secured in place and lightly shake while
holding the dispenser’s cover with you your ngers.
3. Pour out residual soap by tilting the dispenser with the soap compartment opening
directed downwards. See image below:
4. If necessary, repeat all the above-mentioned activities.
5. NEVER POUR OUT SOAP OR RESIDUAL SOAP WITH THE SOAP COMPARTMENT OPENING
DIRECTED UPWARDS. This can cause the risk of ooding the batteries chamber and
permanent damage of the dispenser.
1 Dispenser Cover
2 Soap Compartment
3 Batteries Chamber
4 Feeder
5 Soap Outlet
6 Motion Sensor
7 Plus(+) / Minus(-) Buttons For Mode Adjustment
8 Dispenser’s Body
9 Dispenser’s Base