2. Vehicles & accessories
  3. Motor vehicle accessories & components
  4. Motorcycle Accessories
  5. Ortech
  6. 8203-3

Ortech 8203-3 User manual

  • Hello! I'm a chat assistant and I've reviewed the instruction manual for the ORTECH Switches 8203-3. This document covers the necessary steps to safely install these switches, including warnings, wiring instructions and torque specifications. I'm ready to answer your questions about the technical aspects of the device and installation process.
  • What type of conductors should be used?
    What is the required wire gauge?
    What should be done before installation?
    What is the required torque for screws?
    What AWG is required for push wire?
WARNING
Switches
MODEL 8203-3
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent technician.
INSTALLATION
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
1. Use copper conductors only; 15A, 14AWG to 12AWG
2. Risk of electric shock or death. Disconnect power before installing
3. For installation by a qualified person in accordance with national and local electrical codes
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Mississauga, ON L5T 2N1
CAUTION
•Remove insulation from conductors 5/8"
•Side Wire — wrap conductor securely
around terminal screw. Tighten terminal
screws securely, 9-12 pound • inch
(1.0-1.4N • m) of torque
•Push Wire — use solid #14 AWG for 15A
branch circuit ONLY
ORTECH reserves the right to modify at any time, without notice, any or all of our product's
features, designs, components and specifications to meet market changes.
Ground
(Green or
bare wire)
Hot
(Black wire)
Hot (Black wire)
Green
screw
Black
screw
Yellow screw
Yellow
screw
/