Angelo Decor AD97018 Operating instructions

Calla Lily Fountain

Installation and Assembly Instructions

Read these instructions carefully before beginning installation and assembly.

Carefully unpack the carton, and arrange all of the parts in the working area.

Insert the power cord through the

standpipe. Feed the power cord through the bowl. Pull the power cord through the groove

at the bottom of the fountain.

Attach the bowl to the base using the

twist and lock assembly system. Note

the position of the grooves.

Use pliers to extend the pump outlet. Measure the amount of tubing needed.

Cut the tubing to the proper length. Insert the pump outlet into the tubing. Line up the grooves, and then twist

and lock in order to secure it in place.

For best results and longer life, keep the fountain clean. Use a soft cloth and mild soap, and inspect the pump for debris

on a regular basis.

It is recommended that the bowl be kept 3/4 full of water in order to avoid burning out the pump.

This fountain should be stored during the winter, because water that is left to freeze in the bowl may cause cracking.

Disassemble the fountain, remove the pump and all water, and store it in a garage or shed.