Contacta IR-DC5-2KIT User guide

Type
User guide

Contacta IR-DC5-2KIT is a charging system for infrared receivers and hearing loop listener chargers. With a single setup, this kit can recharge batteries of up to 20 devices. It has dual-color LED indicators to display the charging status (red for charging, green for fully charged). Setting up the system is easy - simply connect the bays together using the provided daisy chaining leads and plug it into an electrical outlet. The compact design allows for easy placement in dry and ventilated areas.

Contacta IR-DC5-2KIT is a charging system for infrared receivers and hearing loop listener chargers. With a single setup, this kit can recharge batteries of up to 20 devices. It has dual-color LED indicators to display the charging status (red for charging, green for fully charged). Setting up the system is easy - simply connect the bays together using the provided daisy chaining leads and plug it into an electrical outlet. The compact design allows for easy placement in dry and ventilated areas.

5 Bay IR Receiver/ Hearing Loop
Listener Charger Daisy Chaining Kit
IR-DC5-2KIT
IR-DC5-3KIT
IR-DC5-4KIT
Installation &
User Guide
General information
Thank you for your purchase of the 5 bay charger daisy chaining kit.
Please read through the operating instructions carefully to be able to set up the unit
correctly and to prevent damage to the rechargeable batteries within the receiver.
Included in the standard package:
Please check if all of the following components are included:
10 Bay Charging Kit (IR-DC5-2KIT)
- Power Lead (PS-12V3AMP-UK)
- Daisy Chainging Lead (PS-LINK-2.1)
- 2 x 5 Bay Chargers (IR-RX2-DC5)
20 Bay Charging Kit (IR-DC5-4KIT)
- Power Lead (PS-12V3AMP-UK)
- 3 x Daisy Chainging Lead (PS-LINK-2.1)
- 4 x 5 Bay Chargers (IR-RX2-DC5)
If any parts are missing, please immediately contact your dealer or the
manufacturer directly.
Function
This charging kit is able to recharge the batteries of 10, 15 or 20 infrared receiver/
hearing loop listener chargers using a single set up.
Setup
Place the set up in a dry and ventilated position. Connect the power supply unit with
the charger to the first bay, then using the daisy chaining leads, link the bays together
as shown below. Then plug the set up into a electrical mains outlet.
Charging the receivers:
When a receiver is placed into the charging bay, the control lamp lights up in red. After
the receiver is fully charged, the control lamp will display a green light. It may take up
to several hours until a receiver is fully charged.
The control lamp switches off when the receiver is removed from the bay.
2 English
15 Bay Charging Kit (IR-DC5-3KIT)
- Power Lead (PS-12V3AMP-UK)
- 2 x Daisy Chainging Lead (PS-LINK-2.1)
- 3 x 5 Bay Chargers (IR-RX2-DC5)
Warranty
Should a malfunction occur despite the unit having been set up and operated correct-
ly, please contact your dealer or the manufacturer directly.
This warranty covers the repair of the product and returning it to you free of charge.
The warranty does not apply to damage caused by incorrect handling or attempts to
repair the unit by people not authorised to do so (destruction of the seal on the unit).
Repairs will only be carried out under warranty if the completed warranty card is retur-
ned accompanied by a copy of the dealer‘s invoice/till receipt.
Always specify the product number in any event.
Disposal of used electric and electronic units (applicable in the countries
of the European Union and other European countries with a separate
collection system). The symbol on the product or the packaging indicates that
this product is not to be handled as ordinary household waste but has to be returned
to a collecting point for the recycling of electric and electronic units. You protect the
environment and health of your fellow men by the correct disposal of this products.
Environment and health are endangered by a faulty disposal. Material recycling helps
to reduce the consumption of raw material.
You will receive further information on the recyc ling of this product from your local
community, your communal disposal company or your local dealer.
Specifications:
Power supply: 100-240 Volt AC 50/60 Hz
Number of charging bays: DO NOT exceed x4 units (20 bays).
Control lamps: Dual colour LED (red / green)
Dimensions: L 85 mm x W 135 mm x H 32 mm
Weight: approx. 190 g
This device complies with the following EU directives:
- Low Voltage Directive 2014/35/EC
- EMC Directive 2014/30/EC
- RoHS Directive 2011/65/EC
- WEEE Directive 2012/19/EC
Compliance with the directives listed above is confirmed by the CE seal on the device.
Technical specifications subject to change without prior notification.
English 3
RM5258/C_2018-12
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Contacta IR-DC5-2KIT User guide

Type
User guide

Contacta IR-DC5-2KIT is a charging system for infrared receivers and hearing loop listener chargers. With a single setup, this kit can recharge batteries of up to 20 devices. It has dual-color LED indicators to display the charging status (red for charging, green for fully charged). Setting up the system is easy - simply connect the bays together using the provided daisy chaining leads and plug it into an electrical outlet. The compact design allows for easy placement in dry and ventilated areas.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI