Green Series 900 Procedure Light Veterinary

Hill-Rom Green Series 900 Procedure Light Veterinary, Green Series 900 Procedure Light Assembly Instructions

  • Hello! I'm your chat assistant. I've reviewed the Assembly Instructions for the Procedure Light Green Series GS 900 on Mobile Stand. This document provides detailed steps on assembling the product, from attaching the wheels to connecting the luminaire. I'm ready to answer your questions about the assembly process and the features of the device.
  • How many boxes does the product ship in?
    How many wheels of each type are included?
    What do the instructions mention about the grey protective cover?
    What is the next step after making the electrical connection?
    What should be done after placing securing segment into a slot?
1
GS 900 on Mobile Stand Assembly Instructions
2
GS 900 on Mobile Stand Assembly Instructions
Ships in 3 boxes
3
GS 900 on Mobile Stand Assembly Instructions
(2) wheels with brakes
(2) wheels without brakes
4
GS 900 on Mobile Stand Assembly Instructions
(2) wheels with brakes
go through the ring cable
(2) wheels without brakes
5
GS 900 on Mobile Stand Assembly Instructions
Place wheels with brakes through ring cable and
insert completely
6
GS 900 on Mobile Stand Assembly Instructions
Insert two wheels without brakes completely
7
GS 900 on Mobile Stand Assembly Instructions
8
GS 900 on Mobile Stand Assembly Instructions
Parts included with Mobile Stand
9
GS 900 on Mobile Stand Assembly Instructions
Tools not included
10
GS 900 on Mobile Stand Assembly Instructions
Insert two screws into pole
11
GS 900 on Mobile Stand Assembly Instructions
12
GS 900 on Mobile Stand Assembly Instructions
Insert the tripod tube so that the recess in the tube is seated in the nose of the tripod base and cannot be rotated any more
13
GS 900 on Mobile Stand Assembly Instructions
Assemble the
winged screw with
the spring washer
and tighten
14
GS 900 on Mobile Stand Assembly Instructions
15
GS 900 on Mobile Stand Assembly Instructions
Remove and discard
grey protective cover
16
GS 900 on Mobile Stand Assembly Instructions
Unscrew the
Phillips/plus-slotted
screw, pull the cover off,
pull cord through the top
opening and insert the
spring arm
17
GS 900 on Mobile Stand Assembly Instructions
Place the disk over spring arm
18
GS 900 on Mobile Stand Assembly Instructions
Place retaining ring over spring arm and secure into the pin groove
19
GS 900 on Mobile Stand Assembly Instructions
Make the electrical connection, tuck wires back inside, replace cover and tighten Phillips/plus screw
20
GS 900 on Mobile Stand Assembly Instructions
Remove and discard
grey protective cover
/