2. Risk of fire or electric shock. LED strip lights can only be used in a dry location indoors.
1. Risk of electric shock. Do not cut the tape lights when power is applied.
Three Year Warranty:
2. DO NOT install strip lights in a corner, as the strip is not made to bend at 90 degrees.
Minimum bend diameter is 2 inches (Fig. 1).
Installation Guide:
CAUTIONS
NOTES
Parts Diagram
16.5’ 30W Dimmable LED Strip Light with Power Supply
Installation Instructions
MLR-301650D
WARNING / ATTENTION
3. Risk of fire or electric shock. If not qualified, do not attempt installation. Contact a qualified
electrician.
4. Risk of fire or electric shock. Install this kit only in areas where the strip light kit has the construction
features shown in figures and/or drawings.
5. To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp
objects.
6. This light strip is not intended for use with emergency exit fixtures or emergency lights.
1. For your safety, read and understand instructions completely before starting installation.
7. Do not use the strip light kit with anything other than a Class 2 Power Unit.
1. The LED strip can be cut to your desired length. However, the strip can only be cut at the
copper points where a scissor icon is visible. If cut too short, use the supplied connectors
to lengthen.
2. Make sure no bare wires are exposed outside the strip and driver.
3. Do not make or alter any open holes in an enclosure of wiring or electrical components
during installation.
Electrical parameters:
Model
MLR-301650D
Fig. 3
Fig. 2
Fig. 1 Fig. 4
1. Determine a proper indoor location to install strip light kit.
2. If desired location is smaller than length of strip lights, cut the strip lights along the marked locations
(Fig.2). Ensure the lights are not powered on before cutting.
3. If cut too short, use the plasitc connectors given to clip the two strips together. Place one side of the strip
in the plastic connector, then the other side. The connector should snap closed, if the placement of the
lights was correct. (Fig. 3). Note: Total length SHOULD NOT exceed 16.5 feet.
4. To make harsh turns or place strip in corners, use the jump connector to connect two ends of the
LED strip and place in desired location (Fig. 4).
5. Before removing the backside of the tape, clean the location where the lights will be installed to ensure a
secure placement. Remove the back of the tape and secure on desired surface (Fig. 5, 6). When installing, do
not push directly on the LEDs (Fig. 7).
6. To remove strip lights, do not twist the strip or peel off from an extreme angle. Remove the lights by pulling
perpendicular to the light strip (Fig. 8, 9).
7. Once the tape lights are secure, use the supplied wood screws to mount the driver (Fig 10).
8. Using the provided plug, insert into desired outlet. The strip lights are now functional.
Fig. 6 Fig. 7 Fig. 10
Fig. 8
Fig. 5
Fig. 9
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Ortech SL120-25M User manual
-
Belmont Phot-X II 303 Installation guide
-
-
Sanyo KS3082 User manual
-
-
Panasonic KE30NKUA User manual
-
-
Zephyr BMLE30BG Installation guide
-
-
Dometic 630516 User manual