Radio Shack 49-415 User manual

Brand: Radio Shack

Model: 49-415

Type: User manual

RadioShack is a trademark used by Tandy Corporation.

Cat. No. 49-415

Your RadioShack Personal Alarm

quickly triggers when you press a but-

ton or remove the hand strap. It also

detects motion, so you can strategical-

ly place it where motion will trigger the

alarm sound and alert you or deter a

thief. It also has a built-in flashlight.

INSTALLING BATTERIES

Your personal alarm requires one 9-

volt battery to power the alarm and

two AA batteries to power the built-in

flashlight. We recommend alkaline

batteries, such as RadioShack Cat.

Nos. 23-553 and 23-552.

To install the batteries:

1. Gently press and push off the bat-

tery compartment cover.

2. Snap the 9-volt battery’s connec-

tor over the 9-volt terminals and

put the battery into the compart-

ment.

3. Place two AA batteries into the

compartment, matching the polar-

ity symbols (+ and –) marked

inside the compartment.

4. Replace the cover.

If the alarm’s sound or light weakens,

replace the batteries.

ALARM TRIGGERING

The alarm triggers when it detects mo-

tion, when you press a button, or

when you pull off the hand strap.

Motion Alarm

Place the alarm on a flat, stable sur-

face. Gently slide Li

ht/Motion

Alarm to Motion Alarm. The indicator

lights for about 30 seconds. During

this period you can still change the

alarm’s location. After that, any motion

it detects will trigger the alarm.

The alarm sounds for about 20 sec-

onds, then it silences for about 3 sec-

onds and returns to a standby mode.

Any further motion will trigger the

alarm again.

To silence the alarm, slide Li

ht/Mo-

tion Alarm to the middle or Li

ht po-

sition.

illustration of product

illustration showing

battery installation

Personal Alarm

49-415.fm Page 1 Wednesday, August 18, 1999 4:51 PM

RadioShack

A Division of Tandy Corporation

Fort Worth, Texas 76102

1A7 Printed in Hong Kong

Pressing a Button

To trigger the alarm, set Light/Motion

Alarm to the middle or Light position.

Hold down the button near the hand

strap. Release the button to silence

the alarm.

Pulling Off the Hand Strap

Set Light/Motion Alarm to the middle

or Light position. Secure your alarm

and attach the hand strap to your

wrist. If the hand strap comes off, the

alarm sounds until you reinsert the

hand strap into its slot. (Inserting the

hand strap with the rib facing down

makes it easier to pull off the strap

and trigger the alarm.)

USING THE

FLASHLIGHT

Slide Light/Motion Alarm to Light.

The light turns on.

When the bulb burns out, slide and lift

the transparent cover. Turn the bulb

counterclockwise to remove it. Use

Cat. No. 272-1124 as the replace-

ment bulb. Screw in the new bulb and

replace the transparent cover.

CARE

These suggestions will help you care for

the alarm.

• Keep the alarm dry. If it does get wet,

wipe it dry immediately.

• Handle it gently and carefully.

• Use and store the alarm only in normal

temperature environments.

• Keep it away from dust and dirt,.

• Wipe the alarm with a damp cloth

occasionally. Do not use harsh chemi-

cals, cleaning solvents, or strong

detergents on it

• Use only fresh batteries of the required

size and type. Always remove old or

weak batteries. Batteries can leak

chemicals that can destroy electronic

circuits.

Modifying or tampering with your alarm’s in-

ternal components can cause a malfunction

and might invalidate your warranty. If the

alarm does not perform as it should, take it

to your local RadioShack store.

SPECIFICATIONS

Detection Method ..........Vibration Switch

Power ..........One DC 9V Battery (Alarm)

Two AA Batteries (Flashlight)

Standby Current ..........................0.3 mA

Delay Time for Alarm....................30 sec

Operating Temperature ...........14–140°F

Dimensions.............51/4 × 2 × 11/4 inches

Weight ........................... Approx. 3.75 oz

49-415.fm Page 2 Wednesday, August 18, 1999 4:51 PM

RadioShack

A Division of Tandy Corporation

Fort Worth, Texas 76102

1A7 Printed in Hong Kong

49-415.fm Page 3 Wednesday, August 18, 1999 4:51 PM

RadioShack

A Division of Tandy Corporation

Fort Worth, Texas 76102

1A7 Printed in Hong Kong

RadioShack Limited Warranty

This product is warranted a

ainst defects for 1

ear from date

of purchase from RadioShack compan

-owned stores and

authorized RadioShack franchisees and dealers. Within this

period, we will repair it without char

e for parts and labor.

Simpl

bring your RadioShack sales slip as proof of pur-

chase date to an

RadioShack store. Warrant

does not

cover transportation costs. Nor does it cover a product sub-

jected to misuse or accidental dama

EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO

EXPRESS WARRANTIES AND ANY IMPLIED WARRAN-

TIES ARE LIMITED IN DURATION TO THE DURATION OF

THE WRITTEN LIMITED WARRANTIES CONTAINED

HEREIN. Some states do not permit limitation or exclusion of

implied warranties; therefore, the aforesaid limitation(s) or

exclusion(s) ma

not appl

to the purchaser.

This warranty gives you specific legal rights and you may also have other

rights which vary from state to state.

We Service What We Sell 10/95

49-415.fm Page 4 Wednesday, August 18, 1999 4:51 PM

Radio Shack 49-415 User manual

Radio Shack 49-415 User manual

Radio Shack 49-415 User manual

Related papers

Other documents