2. Home
  3. Domestic appliances
  4. Climate control
  5. Fireplaces
  6. White Mountain Hearth
  7. Ridgeback Liner for Boulevard Direct-Vent 36 & 48

White Mountain Hearth Ridgeback Liner for Boulevard Direct-Vent 36 & 48 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the White Mountain Hearth Ridgeback Liner for Boulevard Direct-Vent 36 & 48 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
36466-1-0619 Page 1Empire Comfort Systems Inc. • Belleville, IL
CARTON CONTENTS:
• Liner Panel
• Screw Package
• Side Retainer
Brackets (Qty. 2)
TOOLS NEEDED:
• Gloves
• Eye Protection
• 5/16" Hex Driver
STANDARD LINER REMOVAL
CAUTION
Sharp edges! Do not install liner without gloves.
1.
Refertothereplaceinstallationmanualforremovalof
theBarrierandGlassDoorassembliespriortoremovalof
thestandardliner,andinstallationofthenewlineroption.
2. Usinga5/16"Hexdrive,removethescrewatthetoprear
corneroftheRightandLeftStandardLinerPanels.Pull
forwardonthesidelinerstoremove.Ifanyinsulation
adherestothereboxsidewalls,gentlyremoveusing
gloves and discard.
3. Removethetwoscrewslocatedatthetopoftherear
linerpanelandremovethepanel.IMPORTANT Reinstall
thesetwoscrewsintotherearwallofthereboxtoseal
upholes. If anyinsulation adheres tothe rebox rear
wall,gentlyremovetheinsulationanddiscard.
4. The side and rear liners may be discarded if being
replacedwiththeRidgebacklinerkit.
5. Removethe(2)#10x½"screwsfromeachofthefront
sidelinerbracketsandremovethebrackets.Retainthe
screws for installation of the new side liner brackets
includedwiththeRidgebackLinerkit.
INSTALLATION
6. Thehearthandburnercovermustbeclearofdecorative
media.
7.
Carefully unpack the liner,verify that all components
areincluded,andinspectforhiddendamage,priorto
installation.
8.
RemovethefrontGlassRetainer(hearthledge)bylifting
itupandout,thensetitaside.
9. Usea5/16"NutDrivertoinstallthetwoSideRetainer
Brackets at the front left and right side openings of
the rebox with (2) # 10 x ½" screws each. Use the
screwsremovedinstep5toattachthebrackets.These
bracketsmustbeinstalledsotheanglebreakisfacing
rearward. See Figures 1 and 2.
Figure 1
Figure 2
CAUTION
When installing the liner, use extreme care to protect
the pilot assembly and igniter probes! See Figure 3.
CAUTION:
PILOT/IGNIT
OR PROBES
Figure 3
DVP(36,48)LPZ-1 RIDGEBACK LINER KIT
FOR USE ON: DVLL(36,48)BP SERIES FIREPLACES ONLY
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION.
INSTALLATION INSTRUCTIONS
CAUTION:
PILOT/IGNITOR
PROBES
36466-1-0619Page 2 Empire Comfort Systems Inc. • Belleville, IL
10. Toinstallthelinerpanel,itworksbestiftherightside
is placed into the rebox rst. See Figure 4. When
installingtheliner,somegentletwistingofthelinerwill
berequired.Thelinerwillneedtobepushedbackinto
the corners of the rebox just enough to engage the
right front edge of the liner into the right side retainer
bracket.See Figure 4.
CAUTION:
PILOT/IGNITOR PROBES
TWIST PANEL TO INSTALL
Figure 4
11. Once the rightendofthe liner is lockedintotheright
sidebracket,continuetoworkintheleftsideoftheliner
until the complete liner is setting inside the replace.
See Figure 5.
12. Tocompletethelinerinstallation,pushtheleftsideof
the liner towards the left rear corner of the replace.
Pushinwardjustenoughtoengagetheleftendofthe
linerintotheleftsidelinerbracket.See Figure 5. The
lineredgesareheldinplacebythesidebrackets.The
forward pressure of the liner keepsthe liner in place,
duetotheradiusrearcornersontheliner.
See Figure 5 inset.
LINER BRACKET
LINER
ONCE THE LINER IS INSIDE THE
FIREPLACE, PUSH ON THE REAR
ROUNDED CORNERS OF THE LINER.
FLEX LINER JUST ENOUGHTO ALLO
W
THE FRONT EDGES OF THE LINER TO
ENGAGE THE “V” SHAPED RETAINER
BRACKETS
Figure 5
13. Once both ends of the liner have been securely
positioned and retained, check to see that the liner
is centered left to right. This can be done visually by
checkthedistancetheradiuscornersarepositionedin
relationtotherearcornersoftheburnerscreen.
See Figure 6.
Figure 6
14. ReplacetheGlassRetainer.
15. Adddecorativemediaasdesired.
16. ReplaceGlassDoorandBarrierassemblies.
17. Installationiscomplete.
36466-1-0619 Page 3Empire Comfort Systems Inc. • Belleville, IL
LINER KIT PARTS LIST
Index
Number
MODELS
Description
Quantity
Supplied
DVP36LPZ DVP48LPZ
Part Number Part Number
1 40529 37104 RidgebackLiner,Bronze 1
2 36460 36460 Bracket, Front Liner 2
3 R2737 R2737 Screw,#10x1/2 4
3
2
1
3
2
36466-1-0619Page 4
www.empirecomfort.com
Empire Comfort Systems Inc.
Belleville, IL
Ifyouhaveageneralquestion
aboutourproducts,pleasee-mail
usat[email protected].
Ifyouhaveaserviceorrepair
question,pleasecontactyourdealer.
/