86127-1
D9417-1
®
WheelPilot
Quick Reference Guide
SmartPilot
®
ST6002 Controller
Use disp to adjust lighting level.
Wait 10 sec to return to previous mode.
N.B. Refer to section 1.5 of the
ST6002 Operating Guide for full details
Use -1 or +1 to adjust response level.
Press disp to return to previous mode.
1 sec1 sec
Auto Tack
STARBOARD
Auto Tack
PORT
Wind
Wind
Wind
WIND
Autopilot response controls course keeping accuracy.
Higher response settings keep a tighter course but
increase the amount of drive activity and battery use.
Set to a level appropriate for your needs
To Adjust Lighting Level
To Automatically Steer
to a Fixed Wind Angle
Autotack
To Adjust Autopilot
Course-keeping Accuracy
GMA
GMA
GMA
GMA
GMA
55˚
85˚
D9418-1
Display Layout
To activate the Autopilot
For Manual Control
To change the
Autopilot Heading
To follow a Route
set on a Chartplotter
standby
Press for
Manual Control
auto
Press to activate
the Autopilot
track
When the Autopilot
is activated, press
to follow a route
from a connected
navigation system.
Press again to accept
the new course
course change keys
Port 1˚ Starboard 1˚
Port 10˚ Starboard 10˚
disp
Press to display
data pages
Press for 1 second
for lamp control
Press for 3 seconds
for power off
x3x3
OK?OK?
Engage
the clutch
Release the clutch
GMA
GMA
GMA
GMA
GMA
GMA
GMA
GMA
GMA
GMA
1
1
3
2
2
-
1
-
2
Raymarine Marine Instruments ST6002 User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Raymarine SmartPilot SPX-10 Setup Manual
-
-
-
-
-
-
-
-
-
Raymarine SmartPilot X-5R Installation guide