5
1
8
"
3
1
8
"
MMARC Masonry Arch Kit
For Use With Grand Meridian Models:
MM33, MM39(VF), MM44(VF), MM49(VF) and MMST43
INSTALLATION INSTRUCTIONS
Figure 2 - Cutting Arches
Figure 1 - cutting notch to dimensions, side view
Figure 4 - Final Assembly
Figure 3 - Mounting Mortar Arches
Cut to dimensions
Smaller End
of Slope
¼'' Tapcon
Screw
Mortar
Arch
Lintel
(3")
DRILL T HRU Ø
1
4
"
3"
1
1
2
"
1. Notch out the top front of both side walls using a masonry
blade.
2. Cut to dimensions as shown in Figure 1.
3. Set mortar arches in place and drill Ø1/8'' pilot holes into
lintel. Secure arches with 1/4'' Tapcon screws.
Note: smaller end of slope on arch is positioned towards
the inside of the replace as shown in Figure 3.
Note: Arch is made for 49'' unit. If used in smaller models,
cut down to size needed.
126342-01
REV. A
04/12
2701 S. Harbor Blvd.
Santa Ana, CA 92704
1-866-328-4537
www.fmiproducts.com
/
