SPT 30211 Operating instructions

PORTABLE AND BUILT IN DISHWASHER CHANGE CONTROL AND MAIN

PC BOARDS

Open the door. Remove the screws in the door

Some of the screws are circled in red. There are screws on the left side that are not

circled. There are also four screws toward the bottom (two on each side). Unscrew the

screws and gently pull the paneling off. Face the front of the unit and pull the face plate

off of the paneling. The boards are on the under side of the face plate

The main pc board is on the left. The control pc board is actually 3 pieces. You can see

one piece on the right. The other two pieces are below the main pc board

Here is a close up of the main pc board. Remove the two screws in red and pull the board

out of the white plastic housing. Pull the white plastic housing piece away

Here we see the three parts of the control pc board. Unscrew the screws holding the

boards in. The wire connections all clip in. Replace them one at a time, to avoid

confusion