PORTABLE AND BUILT IN DISHWASHER CHANGE CONTROL AND MAIN
PC BOARDS
Open the door. Remove the screws in the door
Some of the screws are circled in red. There are screws on the left side that are not
circled. There are also four screws toward the bottom (two on each side). Unscrew the
screws and gently pull the paneling off. Face the front of the unit and pull the face plate
off of the paneling. The boards are on the under side of the face plate
The main pc board is on the left. The control pc board is actually 3 pieces. You can see
one piece on the right. The other two pieces are below the main pc board
Here is a close up of the main pc board. Remove the two screws in red and pull the board
out of the white plastic housing. Pull the white plastic housing piece away
Here we see the three parts of the control pc board. Unscrew the screws holding the
boards in. The wire connections all clip in. Replace them one at a time, to avoid
confusion
/