Extron P/2 DA1 & P/2 DA1 USB User manual
- Category
- Holders
- Type
- User manual
Extron P/2 DA1 & P/2 DA1 USB are compact and versatile VGA line drivers designed to enhance and distribute high-quality video signals in various applications.
With support for a wide range of input and output resolutions, including SVGA, VGA, XGA, RGBHV, RGBS, RGsB, and RsGsBs, these devices ensure compatibility with a variety of sources and displays.
Featuring a gain/peaking switch, they provide adjustable signal amplification to compensate for cable loss and maintain optimal image quality over long distances.
Extron P/2 DA1 & P/2 DA1 USB are compact and versatile VGA line drivers designed to enhance and distribute high-quality video signals in various applications.
With support for a wide range of input and output resolutions, including SVGA, VGA, XGA, RGBHV, RGBS, RGsB, and RsGsBs, these devices ensure compatibility with a variety of sources and displays.
Featuring a gain/peaking switch, they provide adjustable signal amplification to compensate for cable loss and maintain optimal image quality over long distances.
User’s Guide
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Kyodo Building
16 Ichibancho
Chiyoda-ku, Tokyo 102-0082 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
© 2006 Extron Electronics. All rights reserved.
VGA Line Driver
68-480-02 Rev. C
07 06
P/2 DA1 USB
Connectors ....................................... (1) 15-pin HD female
Nominal level .................................. 0.7 Vp-p for RGB
Minimum/maximum levels ......... Analog: 0.3 VDC to 1.5 VDC p-p with no
offset at unity gain
Impedance ........................................ 75 ohms
DC offset ........................................... ±5 mV maximum with input at 0 offset
Output resolution may vary depending on whether the
P/2 DA1 USB is attached to the computer at startup, and on the
type of computer you are using.
Sync
Input/output type .......................... RGBHV, RGBS, RGsB, RsGsBs
Input level ........................................ 2.0 V to 5.0 Vp-p
Output level ..................................... TTL: 5 Vp-p
Input impedance ............................. 510 ohms
Output impedance .......................... 75 ohms
Max. propagation delay ................. 18.8 ns
Max. rise/fall time .......................... 4 ns
Polarity ............................................. Positive or negative
General
Power ................................................ USB (5.0 VDC, 0.2 A)
Temperature/humidity .............. Storage: -40 to +158 °F (-40 to +70 °C) /
10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) /
10% to 90%, noncondensing
Rack mount ...................................... No
Enclosure type ................................. Plastic clamshell
Enclosure dimensions .................... 0.6" H x 1.3" W x 3.1" D
1.4 cm H x 3.3 cm W x 7.9 cm D
Product weight ................................ 0.5 lb (0.3 kg)
Shipping weight .............................. 1 lb (1 kg)
Vibration ........................................... ISTA 1A in carton
(International Safe Transit Association)
Listings .............................................. UL, CUL
Compliances .................................... CE
MTBF ................................................. 30,000 hours
Warranty........................................... 3 years parts and labor
Part Number
P/2 DA1 USB ............................... 60-319-03
All nominal levels are at ±10%.
Specifications are subject to change without notice.
P/2 DA1 • Operation and SpecificationsP/2 DA1 • Installation and Operation
Installation
32
VGA IN
POWER
POWER
NORMAL
GAIN/PEAKING
MEDIUM
MAXIMUM
VGA OUT
SIGNAL
SIGNAL
P/2 DA1
4
5
To computer
To display device
6
1
2
3
1
15-pin HD input connector (male)
2
Power LED — Lights to indicate that the P/2 DA1 USB is on.
3
Signal LED — Lights to indicate that an input signal is
being received.
4
Gain/peaking switch — Compensates for cable resistance
and capacitance.
Normal — Output is the same level as input.
Medium — 50% of the total gain is applied. Peaking is
applied.
Maximum — 100% of the total gain is applied. Peaking is
applied.
If the signal cable between the P/2 DA1 USB and the
output device is shorter than approximately 125 feet, and
the gain switch is set to 50% or 100%, the image may be
overcompensated. If the edges of the image seem to exceed
their boundaries, or if thin lines and sharp edges look thick
and fuzzy, try changing the gain/peaking setting.
5
15-pin HD output connector (female)
6
USB power connector — Plug this into a computer’s USB
port to provide power to the P/2 DA1 USB.
Specifications
Video
Gain ................................................... 0 dB, 0.6 dB, 1.2 dB, selectable: when input is
0.7 Vp-p, output is 0.7 V, 0.75 V, 0.8 Vp-p
when switch is at normal, medium, and
maximum positions, respectively
Bandwidth ........................................ 300 MHz (-3 dB)
Note: ID bits will be passed through.
Video input
Number/signal type ...................... 1 VGA-UXGA RGBHV, RGBS, RGsB, RsGsBs
Connectors ....................................... (1) 15-pin male
Nominal level .................................. 0.7 Vp-p for RGB
Minimum/maximum levels ......... Analog: 0.3 VDC to 1.5 VDC p-p with no
offset at unity gain
Impedance ........................................ 75 ohms
Horizontal frequency ..................... 15 kHz to 135 kHz
Vertical frequency ........................... 30 Hz to 170 Hz
Video output
Number/signal type ...................... 1 VGA-UXGA RGBHV, RGBS, RGsB, RsGsBs
The Extron P/2 DA1 USB is a one input, one output VGA line driver.
It boosts the video signal between a laptop or desktop computer
(input device) and a monitor or large screen projector (output device).
Features
• The P/2 DA1 USB accepts and outputs SVGA, VGA, XGA
RGBHV, RGBS, RGsB, and RsGsBs signals.
• The gain/peaking switch increases video signal voltage to
compensate for signal degradation caused by long cables.
Installation
To install the P/2 DA1 USB, do the following:
1. Turn off power to the input and output devices, and unplug
their power cords.
2. Connect the computer to the 15-pin HD male input
connector (see
1
in the “Operation” illustration below).
3. Connect the output device to the 15-pin HD female output
connector (see
5
in the “Operation” illustration below).
4. Plug the P/2 DA1 USB’s power connector into the
computer’s USB port.
5. Reattach power cords, and apply power to the input and
output devices.
Many laptop computers have an external video port, but they
require special commands to output the video to that
connector. Also, many laptops’ screens shut off after the port
is activated. See the computer’s user’s guide for details, or
contact Extron for a list of laptop keyboard commands.
Operation
User’s Guide
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Kyodo Building
16 Ichibancho
Chiyoda-ku, Tokyo 102-0082 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
© 2006 Extron Electronics. All rights reserved.
VGA Line Driver
68-480-02 Rev. C
07 06
P/2 DA1 USB
Connectors ....................................... (1) 15-pin HD female
Nominal level .................................. 0.7 Vp-p for RGB
Minimum/maximum levels ......... Analog: 0.3 VDC to 1.5 VDC p-p with no
offset at unity gain
Impedance ........................................ 75 ohms
DC offset ........................................... ±5 mV maximum with input at 0 offset
Output resolution may vary depending on whether the
P/2 DA1 USB is attached to the computer at startup, and on the
type of computer you are using.
Sync
Input/output type .......................... RGBHV, RGBS, RGsB, RsGsBs
Input level ........................................ 2.0 V to 5.0 Vp-p
Output level ..................................... TTL: 5 Vp-p
Input impedance ............................. 510 ohms
Output impedance .......................... 75 ohms
Max. propagation delay ................. 18.8 ns
Max. rise/fall time .......................... 4 ns
Polarity ............................................. Positive or negative
General
Power ................................................ USB (5.0 VDC, 0.2 A)
Temperature/humidity .............. Storage: -40 to +158 °F (-40 to +70 °C) /
10% to 90%, noncondensing
Operating: +32 to +122 °F (0 to +50 °C) /
10% to 90%, noncondensing
Rack mount ...................................... No
Enclosure type ................................. Plastic clamshell
Enclosure dimensions .................... 0.6" H x 1.3" W x 3.1" D
1.4 cm H x 3.3 cm W x 7.9 cm D
Product weight ................................ 0.5 lb (0.3 kg)
Shipping weight .............................. 1 lb (1 kg)
Vibration ........................................... ISTA 1A in carton
(International Safe Transit Association)
Listings .............................................. UL, CUL
Compliances .................................... CE
MTBF ................................................. 30,000 hours
Warranty........................................... 3 years parts and labor
Part Number
P/2 DA1 USB ............................... 60-319-03
All nominal levels are at ±10%.
Specifications are subject to change without notice.
-
1
-
2
-
3
Extron P/2 DA1 & P/2 DA1 USB User manual
- Category
- Holders
- Type
- User manual
Extron P/2 DA1 & P/2 DA1 USB are compact and versatile VGA line drivers designed to enhance and distribute high-quality video signals in various applications.
With support for a wide range of input and output resolutions, including SVGA, VGA, XGA, RGBHV, RGBS, RGsB, and RsGsBs, these devices ensure compatibility with a variety of sources and displays.
Featuring a gain/peaking switch, they provide adjustable signal amplification to compensate for cable loss and maintain optimal image quality over long distances.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Extron P/2 DA1 User manual
-
Extron IN9128 User manual
-
Extron electronics V-LockTM User manual
-
Extron electronics P/2 DA2 PLUS User manual
-
-
Extron DA4 RGBHV User manual
-
-
Extron electronics RGB 160 User manual
-
Extron electronics IN3254 User manual
-
Extron electronics GLI 350xi User manual
Other documents
-
Extron electronic Video and Sync Converter/Stabilizer SC 210 User manual
-
-
Extron electronics MTP U Series User manual
-
Extron electronics P/2 DA2 PLUS User manual
-
Extron electronics SCS 300 User manual
-
-
Extron electronics P/2 DA6xi s User manual
-
-
Extron electronics P/2 User manual
-
Extron electronics VGA Distribution Amplifiers P/2 DA4xi s User manual
