NOTICE D’UTILISATION
RSBE 2400.1
RADIATEUR SOUFFLANT
Fan heater
notice RSBE 22/05/07 10:21 Page 1
Page is loading ...
Page is loading ...
Page is loading ...
ENGLISH
ENGLISH
For your comfort and safety, ALPATEC has checked all the steps
of manufacturing. The products have been made for you to enjoy
their design and easiness to use.
ALPATEC, a complete range of air conditioners, coolers, fans and
heaters for you to be completely satisfied.
CAUTION
PLEASE READ ALL THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS APPLIANCE.
• Make sure that the voltage rating on the type plate corresponds to your main voltage. If not, see your
retailer and do not connect the appliance.
• Keep out of children or incompetent persons and do not allow them to operate this appliance.
• Only use the appliance for domestic purposes and in the way indicated in these instructions.
• From time to time, check the cord for damages. Never use the appliance if cord or appliance show any
sign of damage.
• Never place the appliance under any electrical connector.
• Make sure that the connection cord does not touch any hot surface.
• Keep combustible materials such as drapes, clothing, towels away from the appliance.
• Do not cover the appliance.
• Keep the appliance at least 1 meter away from walls and any other thing, to permit a good air circulation.
• Never immerse the product in water or any liquid for any reasons. Do not use it at less than 60 cm of a
shower, a bath-tub or a swimming-pool.
• Do not use the appliance outdoor.
• Do not use if you have wet hands.
• Never use the appliance on or near hot surfaces.
• Never move or range the appliance by pulling the cord.
• To avoid any risk of burn, never move the appliance when it is hot.
• Before tidying the appliance, make sure that it is unplugged from the power and that it is completely
cooled.
• Unplug the appliance before cleaning.
• Do not clean the appliance with abrasive chemicals.
• Do introduce neither metallic objects, nor fingers inside the appliance in order to protect you from elec-
trical shock.
• Never use accessories that are not recommended or supplied by the manufacturer. It could constitute a
danger to the user and risk to damage the appliance.
• All interventions made by a non-qualified person can be dangerous; in this case guarantee conditions
would cancel. As all electrical products, a competent electrician must repair it.
THE MANUFACTURER WILL NOT ASSUME ANY RESPONSABILITY IN CASE OF NON ADHERENCE
TO THESE INSTRUCTIONS.
SAVE THIS USER MANUAL CAREFULLY.
5
notice RSBE 22/05/07 10:21 Page 5
PARTS LIST
1. Power switch
2. Touching screen display
3. Automatic cut off
4. MODE touch
5. TIMER touch
6. UP touch
7. DOWN touch
8. Fan visual display
9. Heating visual display
10. Température display
11. Time display (for timer mode)
TO USE
• Place the product on a flat, stable, heat-resistant surface.
• Plug in.
• Press the Main Power Button (5). The screen operates and shows the room temperature.
•
Pr
ess MODE (4) to select one of the three available mode.
First pressure : « Low » mode.
Second pressure : « High » mode.
Third pressure : « Fan » mode.
Fourth pressure : stop.
• In Low or High mode, use UP (6) and DOWN (7) touch to set the desired temperature. Temperature word
flashes on the screen during setting and desired temperature value is shown instead of ambient temper-
ature. Each pressure adds (UP) or withdraw (DOWN) one degree.
•
« Low » mode:
Low word flashes on the screen when this mode is selected.
If the desired temperature is higher than the ambient temperature, the appliance heats with 1100 W
power. The visual displays (8) and (9) appear and move on the screen.
When the ambient temperature reaches the desired temperature, the appliance stops heating (the visual
display (9) disappear) ; it fans for a few seconds and stops totally (the visual display (8) disappear).
If the ambient temperature decreases and reaches 3°C below the desired temperature, the heater starts
again.
•
« High » mode: High word flashes on the screen when this mode is selected.
If the desired temperature is higher than the ambient temperature, the appliance heats with 2400W power.
The visual displays (8) and (9) appear and move on the screen.
6
5 764
1
2
8
9
10
11
3
notice RSBE 22/05/07 10:21 Page 6
When the ambient temperature reaches the desired temperature, the appliance stops heating (the visual
display (9) disappear) ; it fans for a few seconds and stops totally (the visual display (8) disappear).
If the ambient temperature decreases and reaches 3°C below the desired temperature, the heater starts
again.
• « Fan » mode:
Fan flashes on the screen when this mode is selected.
The appliance fans only (no heating) and the visual display (8) moves on the screen.
UP (6) and DOWN (7) touches are not available in this mode.
• Stop:
In « Low » mode, press MODE touch (4) three times to stop the heater. The appliance will fan only for a
few seconds and then stops.
In « High » mode, press MODE touch (4) two times to stop the heater. The appliance will fan only for a few
seconds and then stops.
In « Fan » mode, press MODE touch (4) one times to stop the appliance.
• Press Main Power Button (6) to shut off completely the heater.
• Unplug the heater if you do not use it for a long time.
TIMER:
This heater is equipped with a timer that can be set from 1 to 12 hours.
•
Press Timer touch (5) to set the desired time (each pressure adds 1 hour).
•
When the timer is set, countdown will begin after no buttons are pressed for five seconds. The
display will continue to show the remaining time.
•
The heater will shut off when the set time has elapsed; the fan motor will continue to run for 10
seconds for the heater to cool down.
To cancel the TIMER mode press the TIMER button until TIMER 0:00 appears on the display.
MAINTENANCE
• Before any cleaning or maintenance operation, switch off and unplug the appliance.
Ensure it is perfectly cooled.
• To remove the dust, wipe your appliance with a cloth.
• Never use abrasives or detergents.
7
notice RSBE 22/05/07 10:21 Page 7
Page is loading ...
/