Datum Systems VoidMate Installation guide

Brand
Datum Systems
Model
VoidMate
Type
Installation guide
Base Plate
Foot
End Clamp
Sensor
Plug
On / O Switch
Solar Panel
Sensor
Clamp
Shoulder
Gaiter
1. VoidMate Glossary.
24/7 Helpline: 0845 600 2511 [email protected]
2. Create a small void in the ballast between sleepers and slide
the VoidMate under the rail.
4. Slide clamp over the foot of the rail.
6. Fit sensor loosely to side of VoidMate.
3. Ensure the VoidMate base is flush under the rail.
The bracket should sit on the foot of the rail as shown.
5. Tighten the bolts on the clamp repetitively and alternatively
using the M10 Allen key until secure.
Systems
VoidMate
TRACK VOID MONITOR
CLOUD STORAGE
Call Datum
24/7 Helpline:
0845 600 2511
11. The VoidMate will continuously stream information via
Platform Interactive.
9. Once fitted check sensor is free to move and switch on
the VoidMate.
10. Call Datum 24/7 Helpline to ensure device is connected.
Provide them with the information listed.
Head Oce
Datum House
The Pavilions
Bridge Hall Lane
Bury, Lancashire
United Kingdom
BL9 7NX
+44 (0) 161 797 5511
[email protected]
www.datummonitoring.com
@TheDATUMGroup
@DatumMonitoring
8. Insert sensor plug and screw in finger tight.7. Position sensor to sit halfway in its travel range, remove or add
ballast as necessary.
CONTACT DETAILS
Removing the VoidMate
1. Switch o the VoidMate.
2. Fully unscrew sensor plug.
3. Loosen sensor clamp and detach
from VoidMate.
4. Loosen and open the end clamp.
5. Remove the Voidmate.
Serial Number
Company Name
Site Location
Alarm Limit
Alarm Recipients
  • Page 1 1
  • Page 2 2

Datum Systems VoidMate Installation guide

Brand
Datum Systems
Model
VoidMate
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents