Instruction Manual

Absorption refrigerator

30AMN, 30ABN, 40 AME, 30N

1

Instruction Manual

Absorption refrigerator

30AMN, 30ABN, 40 AME, 30N

 Do not work on live electrical circuits. Turn off power sources before attempting to remove, service,

 Do not modify, bypass, or eliminate any of the refrigerator's electrical components, electronic

 Do not wet or spray liquids on or near electrical connections or electronic components. Most

 The cooling unit is a sealed system under pressure! Do not try to repair or recharge the cooling

 During cooling the condensator which is situated in backside could have higher temperature.

 Operate and remove the refrigerator very carefully to prevent strokes, shaking which can

 Make sure the installation has been referend to this manual.

Incorrect ventilation can cause imperfect operation or damage and as a consequence loss of

warranty. Ensure the air flow in the lower intake vent, through the refrigerator coils and

2

condenser, and out the upper exhaust vent is not blocked or decreased. Pay high attention to

adhere to the installation scheme, always keep completely free ventilation of backside!

Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight

may affect the acrylic coating and heat sources may increase electrical consumption.

Pay attention to horizontal location of refrigerator. You can use water level for certain.

Outlet space can be cover up by grid from design reasons.

2. Ideal outlet of warm air will be ensured in case you will install product into the furniture without back side. Warm

air must be outlet to the room, not to close space like other cabinet.

3. For optimal convection is necessary to make sure the air supply in the front part of furniture, for example with

ventilation grid or open plinth in whole width. Minimum size of ventilation leak must be 400 x 50 mm (200 cm

).

4. Allow 10mm of space between the refrigerator and sides of locker, which allows the proper air ventilation .

No safes, TV, fixtures and fittings should be situated on the refrigerator!

3

The refrigerator is equipped with a two prong (grounded) plug for protection against shock hazards and should be

Supplier isnt responsible for damage and injury which has been caused by infringement of this

instruction manual.

It may be the best time to make effective cleaning of the cabinet interior and other parts of the refrigerator every

time after the defrosting has been exercised. Remove all stored foods. Wash out cabinet with mild soap and

IMPORTANT

Don’t use abrasive or caustic cleaning powder, polishes, cleaning paste, gasoline, turpentine or others. Use a

Minibars are tested in the manufactory. Despite of this, after first filled of shelfes in doors of minibars may be

shelfes defected little bit. This may caused worst manipulation closing the door, mainly at freestanding minibars.

To the balanced of door is needed:

- Loosen screws gently and tighten the screws which are parts of lower and upper hinge

- Set up again the regulation screws at the back side of refrigerator

- Double check the quality of shutting the door with beverages

Before shut-down all beverages should be takes away from refrigerator, turn off power sources and clean

interior carefully. Let the door opened to avoid bad smell.

If your refrigerator is not working properly, firstly do the following steps before contact authorizated

4

 Always keep completely free ventilation of backside

 Semantic aggregate is always clean

Check the following trouble shooting hints

 Refrigerator plug is plugged properly

 Electrical connection and jumper cabel hasnt been interruped

 Main circuit-breaker hasnt been switched off or mains fuse hasnt been damaged

Following steps are recommended:

 Throw paper, carton and boxes into the waste container destined for this purpose

 Baverages should be located so that it wont have any influence over the proper air ventilation

 Refrigerator is intended for beverages, not for foodstuff

Refrigerator has only one control for regulating the temperature. The temperature control is located on the upper

right hand corner of the compartment.. Refrigerator is operating automatically. If you want to turn off the

refrigerator you have to unplug it.

You should install the refrigerator in a place where the ambient temperature is

between +10°C - +20°C. If the ambient temperature is above or below recommended

temperatures, the performance of the unit may be affected. Inner temperature of

5

Don’t use abrasive or caustic cleaning powder, polishes, cleaning paste, gasoline, turpentine or other similar. Use

a damp cloth for wiping and finish with a soft dry cloth.

Do not expose door-gutter seal to oily environmernt. Clean door-gutter seal very carefully and regularly.

At least once a year clean the aggregate in the back of the refrigerator – to remove the dust use soft cloth or

vacuum cleaner. That way you will prevent the drop of cooling power and you will extend the lifetime period of

your refrigerator.

Cooling medium: compound of ammonia and distilled water, content of ammonia is 23%

6

the damage during the transportation.

7