Page 1 of 2
Circlet
Assembly Instructions
Component List
H Frame (x2) Shared casting (x2)
Circlet rail (x2) Outside rail (x2)
Center leg (x4) Outside leg (x4)
Worksurface (x4) Divider screen (x4) Modesty (x4)
Wirebaskets (x4) Hanger Cap (x8) Hanger Column (x8)
M10 BHCS (x4) M8 SHCS (x8) M5 BHCS (x8)
Allen Wrench Allen Wrench Allen Wrench
3mm (x1) 5mm (x1) 6mm (x1)
Step 1: Assemble Frame. Assemble 2 legs to each
half of the H Frame using enclosed M10 BHCS.
(2 Sets)
Step 2: Assemble both halves of the H Frame using
the shared castings and tighten the set screws in
the shared castings.
Step 3: Assemble 2 outside leg assemblies. Make
sure to use circlet rails. (2 Sets)
Step 4: Attach 1 outside leg assembly to the center
H Frame using enclosed M8 SHCS.
Step 5: Assemble outside rails to outside legs both
sides and tighten set screws.
Step 6: Assemble the 2
nd
leg assembly to complete
Frame. Tighten set screws using enclosed M8 SHCS
to attach H Frame. Frame complete.
Allen Wrench
6mm.
Allen Wrench
5mm.
Allen Wrench
5mm.
Allen Wrench
5mm.
Allen Wrench
5mm.
Allen Wrench
5mm.
Toolbar
stem
Page 2 of 2
Step 7: Assemble Dividers. Align hanging pins on
Toolbar with the slots on the Frame then tighten the
set screws in both slots. Repeat 4 times.
Step 8: Assemble Wirebaskets. Assemble 2 Hanger
Column with the Wirebasket and Hanger Cap using
enclosed M5 BHCS.
Step 9: Attach Wirebaskets. Align Wirebasket
assembly with pins on the underside of the Toolbar
then tighten set screws. Repeat 4 times.
Step 10: Assemble Worksurfaces. Align Wedge
Block under the Worksurface to hang over the back
Frame rail. Push the Locking Handles in until
handles are parallel with rail. Repeat 4 times.
Step 11: Assemble Modesty Screens. Align Screen
hook with Toolbar. Repeat 4 times. Assembly
complete.
Unlock position Lock position
Allen Wrench
5mm.
Allen Wrench
5mm.
Allen Wrench
3mm.
/
