Glowshift GS-OHD-289.5, GS-OHD-289.1, GS-OHD-289.4, GS-OHD-289.7 Operating instructions

I've reviewed the provided instructions for the GlowShift Overhead T-Top Pod G-Body. This document contains a step-by-step guide for installing the dual gauge pod in a G-Body vehicle, including removing trim, attaching the pod, and wiring the gauges. I'm ready to answer any specific questions you have about the installation process or the product itself.
How many screws need to be removed from the factory T-Top trim?

What should be used to clean the factory trim?

Is drilling required for installation?

Rev. 2022

Dual Gauge Overhead T-Top Pod for G-Body

1. Start by removing the 4 screws on the factory T-Top trim using a Phillips head screwdriver.

2. Clean the surface of the factory trim with an alcohol prep pad to remove any dirt and grease.

3. Remove the backing from the included double-sided tap on the T-Top pod and secure to the factory trim.

4. Reinstall the trim and secure to the vehicle with the factory screws.

5. Follow the instructions included with each gauge to finalize the gauge installation process, it may be

necessary to drill a hole in the factory trim to allow the wires to pass through.

Rev. 2022

All GlowShift Products are subject to the GlowShift Limited Warranty. Please visit

https://www.glowshiftdirect.com/warranty-policies to review complete Warranty, Terms, and Conditions.