Leg wires on warming rack
must run underneath surface.
Hinge Pin
and Hitch Pin
Qty: 2
Qty: 2
Qty:2
Qty: 2
462835205_Eng
Items to Assemble:
2 Wheel Assemblies
2 Hitch Pins
2 Leg Extenders
Items to Assemble:
2 Leg Assemblies
1 Bottom Shelf
6 Carriage Bolts
6 Wing Nuts
Qty: 6
Qty: 6
Place bottom shelf and legs as shown.
After assembling tighten all wing nuts.
Right Side:
Attach 2 Carriage Bolts and Wing Nuts in
front and back.
Left Side:
Place 1 Carriage Bolt
and Wing Nut in upper hole only
Items to Assemble:
1 Grill Lid
2 Hinge Pins
2 Hitch Pins
1 Handle
2 Wing Nuts
1 Logo Plate
Item to Assemble:
1 Panel
2 Push Pins
Qty: 2
Assemble front panel by placing
tabs into slots on bottom shelf.
Attach with push pins.
Attach wheels with hitch pins
Items to Assemble:
1 Grill Bottom
1 Heat Shield
4 Carriage Bolts
4 Wing Nuts
2 Control Knobs
Qty. 4
Qty.4
Items to Assemble:
2 Shelves
8 Wing Screws
Qty: 8
See Use & Care Manual for “Match Lighting Instructions” and to
perform the Burner Flame Check” and important safety
instructions before using.
Hang grease clip from center of grill bottom.
Use an empty soup can (not included) to hang
from grease clip.
Items to Assemble:
1 Grease Clip
1 Tank Wire Support Bracket
LP tank is sold separately. Use only with an
(over-fill protection device) OPD equipped LP tank.
Fill and leak check before attaching to grill and regulator.
CAUTION
!
• Failure to install can in clip will cause hot grease
to drip from bottom of grill with risk of fire or
property damage.
• Tank collar opening must face to front of cart
once tank is attached.
• Failure to install tank correctly may allow gas
hose to be damaged in operation, resulting in
the risk of fire.
Items to Assemble:
1 V-Bar
Push v-bar down onto
rest in grill bottom
Items to Assemble:
1 Warming Rack
1 Cooking Grate, Small
1 Cooking Grate, Large
A
B
Insert pivot wire of warming
rack into lid. Flex leg
wires to insert into grill
bottom.
Place cooking grates
into grill bottom.
A
B
1
9
9
8
4
5
6
7
1
2
3
Back of Grill
Grease Clip
/