TTV 678 / TRO 650
As part of Numatic International’s commitment to product support, we advise you to
follow the following simple maintenance steps, to keep your machine working at its
optimum performance.
5
1
2
3
4
5
6
3
4
1
3
4
2
5
6
2
Looking after your Machine
6
If you require further assistance
contact your supervisor:-
........................................................
Your machine serial number is:-
..........................................................
The TTV machine is being used by:-
..........................................................
Always pre-sweep BEFORE using your machine. Replacement duster (Pack of 50) - P/N 629811.
Clean the separator, ush the lter with clean water.
Clean the waste basket lter ush the lter with clean water.
After use, empty the top (waste) tank.
Inspect and clean the oor-tool, wiping the blades with a clean cloth. (Replacement Blades x 2) - P/N 606198
Check all hoses are clear and free from obstruction.
Simply peel off above sticker and carefully stick to a dry, clean and at service. Begin by sticking the top of the poster, slowly smoothing the material working downwards.
This material is a specially developed vinyl that will stick to many surfaces including concrete, brick, plaster and is also re-postionable.
If you are unsure of the suitability of a surface cut a sample using this lower section to stick to a test area.
Numatic international Ltd. accept no responsibility for any damage caused by adhering / removing this sticker from an unsuitable surface.
Printed using Arlon DPF 4300 (Data Sheet included).
Do not stick to re doors / barriers or obscure existing signage.
www.numatic.co.uk
www.numatic.de
www.numatic.ch
www.numatic.fr
www.numatic.nl
www.numatic.co.za
Numatic International Limited, Chard, Somerset, TA20 2GB Tel: +44 01460 68600 Fax: +44 01460 68458
Specication subject to change without prior notice.
03/2014 (A01)