2. Victron energy
  3. Cable for Smart BMS CL 12-100 to MultiPlus

Victron energy Cable for Smart BMS CL 12-100 to MultiPlus, Cable for Smart BMS CL 12/100 to MultiPlus Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Victron energy Cable for Smart BMS CL 12-100 to MultiPlus Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
rev01 14/02/2020
Victron Energy bv / De Paal 35 / 1351 JG ALMERE / The Netherlands
Phone: (+31) (0)36 535 97 00 / www.victronenergy.com
e-mail: sales@victronenergy.com
Cable for Smart BMS CL 12-100 to MultiPlus (PN: ASS070200100)
This cable will allow the MultiPlus 500VA – 1600VA, MultiPlus Compact 800VA – 2kVA and MultiPlus-II models to be
used with BMS products that have no VE.Bus interface, such as the Smart BMS CL 12-100 and the miniBMS. These
MultiPlus models can be controlled from the Load/Charge Disconnect outputs and Load/Charger outputs
respectively.
The cable must be wired to the remote on/off connector of the MultiPlus models:
• When used with the MultiPlus 500VA-1200VA models connect the black wire to the ON terminal and the red
wire to the (+) terminal.
• When used with the MultiPlus Compact 800VA-2kVA models connect the black wire to the middle terminal and
the red wire to the right (IN) terminal.
• When used with the MultiPlus-II models connect the black wire to the lower (-) terminal and the red wire to
the upper (+) remote on-off terminal.
Both the Load/Charge Disconnect outputs of Smart BMS CL 12-100 and Load/Charger outputs of the miniBMS must
be in ‘High’ state in order for the MultiPlus to operate. After shutdown due to low battery voltage, run the alternator
or use a battery charger on the primary side of the BMS to reset the system. The MultiPlus will then switch on and
start charging (if connected to an AC power source).
/