Description
Package contents
Installation
Caution: You must use the
safety cable when attaching
your speakers to walls or
ceilings
Caution: Please make sure
you only use low-impedance
amplifiers with a maximum
output of 50W RMS at 8 Ohms
Your OHO-350 speaker can be set in several different ways:
Please make sure to
connect your amplifier
cable before installing the
base.
Then use the supplied
screws or screws adapted
to your support to attach
the base.
Finally, place the speaker
onto its base and connect
the power supply cord,
then use the safety cable
to secure your speaker
position.
Horizontally Ceiling speaker Wall-mounted
The package must contain the following articles:
- 2 OHO-350 speakers
- 2 magnetised bases
- 1 accessory kit: 4 fixation screws, 2 screws for safety cables and 4 flexible caps to hide the fixation screws
- 1 pair of gloves to prevent the speakers from getting dirty during the installation
Please contact your retailer immediately if one of these articles were to be missing.
Speaker power supply cord
Positive signal connector (red)
Drilled holed to attach the base
Base
Negative signal connector (black)
Speaker
Safety cable
Because AUDIOPHONY
®
takes the utmost care in its products to make sure you only get the best possible quality, our products are subjects to
modifications without prior notice. That is why technical specifications and the products physical configuration might differ from the illustrations.
Make sure you get the latest news and updates about the AUDIOPHONY
®
products on www.audiophony.com
AUDIOPHONY
®
is a trademark of HITMUSIC S.A. - Zone Cahors sud - 46230 FONTANES - FRANCE