![](//vs1.manuzoid.com/store/data-gzf/4fc34bb68ebc750fd2fe5f0d0f2352d2/2/000868720.htmlex.zip/bg1.jpg)
1
All Rights Reserved
Printed in the USA
2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Adapter Kit
2002 and Later Snow/Dozer Blade to 2001 and Earlier GT
Classic Garden Tractor
Part No. 105–1501
Form No. 3327–134
Installation Instructions
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Lever 1 Installing the New Lever
Cable 1 Installing the New Cable
Installing the New Lever
1. Disengage the power take off (PTO), set the parking
brake and turn the ignition key to off. Remove the key.
2. Remove the existing index lever from the snow/dozer
blade (Fig. 1). Save all the hardware.
3. Install the index lever to the new lever (Fig. 1).
4. Attach the new lever to the pivot support using the bolt
(1/2 x 1 in.) and jam nut (1/2 in.). Screw the bolt into
the pivot support until the handle is snug and then
back it off slightly to let the handle pivot freely
(Fig. 1).
5. Rotate the lever to align the hole at the bottom of the
handle with the control rod.
6. Insert the control rod through the handle end and
secure it with a large hairpin cotter (Fig. 1).
1
2
3
5
8
7
6
9
4
10
8
7
6
m–5699
Figure 1
1. Lever
2. Control rod
3. Large hairpin cotter
4. Index lever
5. Z-fitting
6. Bolt, 1/4 x 1 in.
7. Cable clip
8. Locknut, 1/4 in.
9. Bolt, 1/2 x 1 in.
10. Jam nut, 1/2 in.