AMX SC-TC-SM Template

Type
Template

This manual is also suitable for

SVSI N-Series Wall Controller Cut-Out Template
SVSI N-Series Wall Controller Cut-Out Template
4.00”
(101.6 mm)
4.00”
(101.6 mm)
Use this cut-out template to begin installation of your
N-Series Wall Controller (SC-WPC-D/SC-TC-D).
1. When printing this document, please double-check all
print settings:
Print to an 8.5x11 page.
Set Page Scaling to None. DO NOT SHRINK to fit to the
page.
2. Use scissors to cut out the gray area from the template.
3. Tape the cut-out to the mounting surface on your wall
where the N-Series Wall Controller is to be installed.
4. Mark the position on the mounting surface.
5. Double-check all dimensions, positions, and
measurements.
6. Cut the opening in the wall.
7. Continue installation by following the instructions
given in the unit’s Quick Start Guide (included in
shipment and/or available on-line at
www.amx.com/svsi/
).
805-0001 REV: A
4.00”
(101.6 mm)
4.00”
(101.6 mm)
Use this cut-out template to begin installation of your
N-Series Wall Controller (SC-WPC-D/SC-TC-D).
1. When printing this document, please double-check all
print settings:
Print to an 8.5x11 page.
Set Page Scaling to None. DO NOT SHRINK to f it to the
page.
2. Use scissors to cut out the gray area from the template.
3. Tape the cut-out to the mounting surface on your wall
where the N-Series Wall Controller is to be installed.
4. Mark the position on the mounting surface.
5. Double-check all dimensions, positions, and
measurements.
6. Cut the opening in the wall.
7. Continue installation by following the instructions
given in the unit’s Quick Start Guide (included in
shipment and/or available on-line at
www.amx.com/svsi/
).
805-0001 REV: A
805-0001 REV: A
  • Page 1 1

AMX SC-TC-SM Template

Type
Template
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI