Tennant M-T5,M-T7 Instruction Bulletin

Brand: Tennant

Model: M-T5,M-T7

Type: Instruction Bulletin

CONTROL BOARD REPLACEMENT

BATTERY SELECT MODE

KIT NO. 9008406, 9006881, 9006882

Model: T5, T7

9010852 Rev. 01 (03- 2014) Tennant Company www.tennantco.com

Replacement control board must be programmed to accommodate battery type discharge rate. Failure to

properly program new control board may result in battery damage. Perform the Battery Select Mode

procedure as described below:

BATTERY SELECT MODE:

Setup Time: 2 minutes

TOOLS REQUIRED: None

Battery Select Mode Procedure

1. To enter the battery select mode, press and hold the solution flow increase button (+) while turning

key switch ON. Release the solution flow increase button when one of the LED’s on the battery

discharge indicator begins to blink.

2. Refer to the battery selection settings as shown below.

3. To select proper battery, press the solution flow decrease button (- ) to advance selection.

4. Turn key switch OFF to save setting.

Global/WET

(default)

Global/GEL

Red

Yellow

Green

Solution Flow

Increase Button

Solution Flow

decrease Button

Battery

Discharge

Indicator

LED’s

Region/Battery Type

TNV/WET

Europe/WET

T5 Model T7 Model

Blinking LED

Solution Flow

Increase Button

Solution Flow

decrease Button

Region/Battery Type

Blinking LED

Battery

Discharge

Indicator

LED’s

Global/WET

(default)

Global/GEL

Red

Yellow

Green

TNV/WET

Europe/WET

Tennant M-T5,M-T7 Instruction Bulletin

Tennant M-T5,M-T7 Instruction Bulletin

Tennant M-T5,M-T7 Instruction Bulletin

Related papers

Other documents