Allied Brass CV-26D-ABZ, CV-26D-GYM, CV-26D-PEW, CV-26D-SN Installation guide

Hello! I am an AI chatbot trained to assist you with the Allied Brass CV-26D-ABZ Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

Step1: Drill Holes in Wall for screws or screw anchors and attached Mounting plate to Wall

Determine your desired location for installation and make a mark for the location of the mounting plate. Remove mounting

plate from backplate by loosening set screw in backplate as pictured below. Place center hole of mounting plate over mark

made above. Make 2 marks where mounting screws will be placed as shown below. Drill hole at each of the marks. (You may

substitute other style mounting anchors or screws if desired). Place anchors into the holes made. Place mounting plate over

holes and secure to mounting surface using screws as shown below.

No portion of this document or any artwork contained herein should reproduced in any way without the written consent of ALLIED BRASS INC.

INSTALLATION INSTRUCTIONS

CV-26D

MOUNTING PLATE

DRILLED HOLES

DRILLED HOLE

ANCHOR

SCREW

SET SCREW

MOUNTING PLATE

Step2: Attach Bracket to Mounting Plate

Place bracket on mounting plate and secure by tightening set screw as shown below.

MOUNTING PLATE

SET SCREW

BACKPLATE