29
• Do not repair the appliance by yourself. Always contact an author-
ized technician. If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly qualied per-
sons in order to avoid a hazard.
Notes for Use
Unpacking
1. Remove all packaging materials like foils, lling materi-
als, cable holders, and carton packaging.
2. Please unwind the lead completely.
Electrical Connection
1. Make sure that the iron voltage (see name plate) and the
line voltage match.
2. Turn the switches to and the lowest level.
3. The mains plug should only be inserted into a correctly
installed socket with earthing contact.
Connected Wattage
The station has a total maximum wattage of 2000 W. With
this connected load a separate supply line protected by a
16 A household circuit breaker is recommended.
CAUTION: Overload
• If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appliance is
too powerful.
Safety Switch
Your fan heater has a safety switch on the underside of the
appliance. This switches the appliance off as soon as it is
no longer stable and could fall over.
NOTE:
The appliance switches on again automatically as soon as
it is placed in an upright position.
CAUTION:
Place the appliance on a smooth horizontal surface.
Avoid carpets in order to prevent the safety switch from
malfunctioning.
Function Switch
= Off
= Cold air
I = Hot air (1000 W)
II = Hot air (2000 W)
NOTE:
Select low power, for example, for a small room. If this is
not enough, please switch to the high level.
Levels / Heating Power
By regularly switching the fan heater on and off, the thermo-
stat ensures that the desired temperature is maintained.
Lowest level Highest level
In order to nd the ideal thermostat setting, please proceed
as follows:
1. Turn the thermostat control to the highest level.
2. As soon as the desired temperature has been reached,
turn the thermostat control slowly down until the fan
heater turns itself off. The control lamp on the switch
goes off.
The fan heater will now automatically stay at the desired
temperature.
CAUTION:
When the appliance is no longer being used you should
always remove the mains plug.
Oscillation
In order to achieve uniform heating and ventilation the
appliance is also equipped with an oscillation function. This
function is available in all three modes of operation.
• Press the switch on the bottom of the appliance in order
to switch oscillation mode on and off.
CAUTION:
• Never move the swivel mechanism by hand, as other-
wise the mechanism might be damaged.
• Only the switch should be used to change the direction
of ventilation.
NOTE:
The oscillation function continues to work even if the
ventilator switches off.
Cold Air Operation
If you would like to use the appliance as a ventilator please
move the function switch to the ventilator symbol and turn
the temperature control to the highest position.