{
STIHL SG 10 Instruction Manual
Original Instruction ManualPrinted on chlorine-free paper
Printing inks contain vegetable oils, paper can be recycled.
© ANDREAS STIHL AG & Co. KG, 2009
0458-551-0121-A. M4-2.L09.DVI.
0000001166_002_GB
SG 10
English
1
{
Contents
Pictograms
All the pictograms attached to the
machine are shown and explained in this
manual.
Symbols in text
Engineering improvements
STIHL's philosophy is to continually
improve all of its products. For this
reason we may modify the design,
engineering and appearance of our
products periodically.
Therefore, some changes, modifications
and improvements may not be covered
in this manual.
Guide to Using this Manual 1
Safety Precautions and Working
Techniques 2
Filling the Container 5
Spraying 5
After Spraying 6
Main Parts 7
Specifications 8
Quality Certification 8
Guide to Using this Manual
Warning where there is a risk of
an accident or personal injury or
serious damage to property.
Caution where there is a risk of
damaging the machine or its
individual components.
SG 10
English
2
Observe all application local safety
regulations, standards and ordinances.
If you have not used this type of sprayer
before: Have your dealer or other
experienced user show you how to
operate your sprayer or attend a special
course in sprayer operation.
Minors should never be allowed to use a
sprayer.
Bystanders, especially children, and
animals should not be allowed in the
area where a sprayer is in use.
When the sprayer is not in use, put it in
a safe place so that it does not endanger
others. Secure it against unauthorized
use.
The user is responsible for avoiding
injury to third parties or damage to their
property.
Do not lend or rent your sprayer without
the instruction manual. Be sure that
anyone using it understands the
information contained in this manual.
To operate the sprayer you must be
rested, in good physical condition and
mental health.
Do not operate the sprayer if you are
under the influence of any substance
(drugs, alcohol) which might impair
vision, dexterity or judgment.
The sprayer is suitable for spraying
chemicals and other liquids to control
pests and weeds. Typical areas of
application are in fruit, flower and
vegetable gardens, plantations and
forestry.
It must not be used for any other
purpose because of the increased risk of
accidents and damage to the sprayer
itself. Never attempt to modify your
sprayer in any way since this may result
in accidents or damage to the sprayer.
Only use parts and accessories that are
explicity approved for this sprayer by
STIHL or are technically identical. If you
have any questions in this respect,
consult a servicing dealer. Use only high
quality parts and accessories in order to
avoid the risk of accidents and damage
to the sprayer.
STIHL recommends the use of original
STIHL replacement parts and
accessories. They are specifically
designed to match your model and meet
your performance requirements.
Never attempt to modify your sprayer in
any way since this will increase the risk
of personal injury. STIHL excludes all
liability for personal injury and damage
to property caused while using
unauthorized attachments.
Do not operate your sprayer if any of its
components are damaged. Pay special
attention to the tightness of the tank (no
leaks).
Pressurize the tank only with the pump
mounted to the sprayer.
Do not use a pressure washer to clean
the sprayer. The solid jet of water may
damage parts of the sprayer.
Clothing and Equipment
Wear proper protective clothing and
equipment when using, filling and
cleaning the sprayer. Follow the
chemical manufacturer's instructions
with respect to protective equipment.
Immediately change work clothes
contaminated with plant control
chemicals.
For some chemicals it is necessary to
wear impermeable coveralls. If you are
spraying overhead, wear impermeable
head covering.
Safety Precautions and
Working Techniques
Special safety precau-
tions must be observed
when working with this
sprayer.
It is important you read
and understand the
instruction manual before
using your unit for the
first time and keep the
manual in a safe place for
future reference. Non-
observance of the safety
precautions may result in
serious or even fatal
injury.
Clothing must be snug-fit-
ting but allow complete
freedom of movement.
Wear impermeable safety
boots with a non-slip sole
which are resistant to
plant control chemicals.
SG 10
English
3
Do not wear sandals or go barefoot.
Breathing plant control chemicals may
endanger your health. Always wear a
suitable respirator to protect yourself
against health risks and allergic
reactions. Follow the chemical
manufacturer's instructions.
Handling of Chemicals
Read the instructions supplied with the
plant control chemical prior to use.
Follow the instructions with respect to
mixing, using, personal protection
equipment, storage and disposal.
Observe legal requirements for handling
plant control chemicals.
Plant control chemicals may contain
substances that are harmful to humans,
animals, plants and the environment –
risk or poisoning and risk of serious
or fatal injuries!
Plant control chemicals may be used
only by persons trained in their handling
and the appropriate first-aid measures.
Keep instructions or label of the plant
control chemical available at all times in
order to inform the doctor about the
chemical concerned in an emergency.
In an emergency, follow the chemical
manufacturer's instructions provided or
on the label.
Preparing plant control chemicals
Prepare solution of plant control
chemical according to manufacturer's
instructions.
– Only prepare sufficient solution for
the job in hand so that nothing is left
over.
– Mix different plant control chemicals
only in accordance with instructions
– wrong mixtures can produce toxic
fumes or explosive mixtures.
– Never spray liquid plant control
chemicals undiluted.
– Prepare solution and fill the tank
outdoors only or in well-ventilated
locations.
Filling the tank
– Before filling the tank with spray
solution, carry out test run with fresh
water and check all parts of the
sprayer for leaks.
– When filling from central water
supply, do not immerse the end of
the hose in the solution – sudden
low pressure in the system may
cause the solution to be sucked
back into the water supply.
– Stand the sprayer on a level surface
– do not fill the tank above the
maximum mark.
– After filling, fit the tank cover and
tighten it down firmly.
Using the sprayer
– Operate your sprayer outdoors only
or in well-ventilated locations.
– Do not eat, drink or smoke while
working with plant control
chemicals.
– Never blow through nozzles or other
components by mouth.
– Avoid contact with plant control
chemicals – immediately change
clothing contaminated with plant
control chemical.
– Do not spray in windy conditions.
Too high or too low a pressure or
unfavorable weather conditions can
result in the wrong solution
concentration. Overdosing may damage
plants and the environment. Under-
dosing may result in unsuccessful plant
treatment.
In order to reduce the risk of damage to
the environment and plants, do not
operate the sprayer if:
– pressure is too high or too low
– in windy conditions
– at temperatures above 25°C in the
shade
– in direct sunlight
In order to reduce the risk of accidents
and damage to the sprayer, do not
operate the sprayer with:
– flammable liquids
– caustic or corrosive chemicals
– liquids hotter than 50°C
Wear safety glasses.
Wear impermeable
gloves resistant to plant
control chemicals.
SG 10
English
4
Storage
– During work breaks, do not leave
the sprayer in the hot sun or near
any heat source.
– Do not store spray solution in the
tank for longer than one day.
– Store and transport spray solution
only in approved containers.
– Never store the spray solution in
containers intended for foods,
drinks or animal feedstuffs.
– Do not store spray solution with
foods, drinks or animal feedstuffs.
– Keep spray solution out of the reach
of children and animals.
– Store the unit empty and clean. It
must not be under pressure.
– Store the spray solution and unit in
a place secured against
unauthorized use.
– Store the spray solution and unit in
a dry place protected from frost.
Disposal
Never dispose of residual chemicals or
contaminated rinse in waterways,
drains, sewers, street gutters or
manholes.
– Dispose of residual solution and
used containers in accordance with
local waste disposal regulations.
Transporting the Unit
Transporting in a vehicle:
– Properly secure the unit to prevent
turnover and damage.
– The tank must be empty and clean.
Holding and Controlling the Unit
Hold the unit with either the right or left
handle on the handle.
To reduce the risk of spillage and
injury, hold the sprayer upright.
During Operation
Never spray in the direction of
bystanders – risk of injury.
Take special care in slippery conditions
– damp, snow, ice, on slopes or uneven
ground.
Watch out for obstacles: Be careful of
refuse, tree stumps, roots and ditches
which could cause you to trip or stumble.
Never work on a ladder or any other
insecure support.
To reduce the risk of accidents, take a
break in good time to avoid tiredness or
exhaustion.
Work calmly and carefully – in daylight
conditions and only when visibility is
good. Stay alert so as not to endanger
others.
To reduce the risk of electrocution,
never operate this sprayer in the vicinity
of live wires or power cables.
After Finishing Work
Always wash your hands, face and
clothes, if necessary, and clean the unit
after finishing work.
Keep other persons and animals away
from the areas that have been sprayed
and do not walk on them until the plant
control chemical has dried.
Maintenance and Repairs
Do not attempt any maintenance or
repair work not described in the
instruction manual. Have all other work
performed by a servicing dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer. STIHL dealers are
regularly given the opportunity to attend
training courses and are supplied with
the necessary technical information.
Only use high-quality replacement parts
in order to avoid the risk of accidents
and damage to the sprayer. If you have
any questions in this respect, consult a
servicing dealer.
STIHL recommends the use of genuine
STIHL replacement parts. They are
specifically designed to match your
model and meet your performance
requirements.
551BA010 KN
SG 10
English
5
Always clean and empty the tank and
release pressure in the unit before
carrying our any maintenance or repair
work.
When cleaning the tank, tube and hose
system, make sure that other persons
are not endangered by escaping liquid –
risk of injury.
N Stand the tank on a level surface.
N Fill up with thoroughly mixed spray
solution – do not exceed maximum
capacity of 1.6 L (arrow).
N Fit the cover and tighten it down
firmly.
Before Spraying
N Select the nozzle to suit the required
spray rate.
N Fit the nozzle on the spray head.
N Move the pump shaft (1) up and
down uniformly – 20 to 30 strokes
are required to build up operating
pressure.
N Rotate the nozzle (2) to adjust the
spray pattern (fine jet or spray mist).
Check operation of the pressure relief
valve before spraying.
Filling the Container
551BA001 KN
551BA011 KN
Spraying
Spray rate:
Nozzle (black) 150 cm
3
/min
Nozzle
(orange / black) 250 cm
3
/min
551BA012 KN
1
551BA013 KN
2
SG 10
English
6
N Grip the pin (3) on the pressure
relief valve and pull it upwards for a
moment. Air must escape from the
valve.
Spraying
N Press the lever (1) down.
N When the spray pressure begins to
drop, move the pump shaft up and
down uniformly – 15 strokes are
necessary to restore full pressure.
N Grip the pin (3) on the pressure
relief valve and pull it upwards until
the tank is no longer under
pressure.
N Empty the tank in a well ventilated
location.
N Dispose of any residual spray
solution in accordance with
environmental requirements –
follow instructions of chemical
manufacturer.
N Rinse the tank with clean water.
N Fill the tank with clean water, pump
and spray until the tank is empty
and no longer under pressure. Do
not store the sprayer under
pressure or with spray solution in
the tank.
N Lubricate the pump piston with
grease periodically.
551BA014 KN
3
551BA015 KN
1
After Spraying
551BA014 KN
3
SG 10
English
7
1 Handle
2 Nozzle holder
3 Lever
4 Pump shaft
5 Nozzle
6 Pressure relief valve
7 Cover
8 Pump
9 Pick-up tube
10 Sealing ring
11 Solution tank
Main Parts
6
10
7
4
2
1
3
5
8
11
551BA009 KN
9
SG 10
English
8
All STIHL products comply with the
highest quality standards.
An independent organization has
certified that all products manufactured
by STIHL meet the strict requirements of
the ISO 9001 standard for quality
management systems in terms of
product development, materials
purchasing, production, assembly,
documentation and customer service.
Specifications
Spray rate:
Nozzle (black) 150 cm
3
/min
Nozzle
(orange / black) 250 cm
3
/min
Tank capacity: 1.6 L
Weight: 0.6 kg
Quality Certification
000BA025 LÄ
www.stihl.com
*04585510121A*
0458-551-0121-A
0458-551-0121-A
englisch
G
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Solo 453 User manual
-
-
-
-
North Star M2681781B Owner's manual
-
-
-
-
Solo 475 Classic Original Instructions Manual
-
Maruyama MX20 Pro Owner's manual