Livex Lighting 2603-07 Installation guide

Type
Installation guide

This manual is also suitable for

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT# 2592 2594 2597 2603
2606 2608 OUTDOOR POST MOUNT LIGHT FIXTURE
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ASSEMBLING THE FIXTURE (Fig.1).
1. Carefully unpack new fixture and lay all the parts on a
clear surface. Take care not to lose any small parts
necessary for installation.
2. NOTE: Discharge of the loop(A), cover(B) and (C).
3. Attach the candle sleeve(E) over the lamp holder.
4. Install the light bulbs (No Included) in accordance with
the fixture's specifications. DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!
5. Raise the cover(C) and (B) to top of lamp body(D),
aligning the top center hole with the pipe screw, then
lock it securely with the loop(A).
6. Attach the assembly lamp body onto the post (no
included) and lock it securely with the screw (F).
Wiring (Fig.2)
1. Connect the electrical wires as follows. Connect the
black wire from the fixture to the black house (hot)
wire. Connect the white wire from the fixture to the
white (neutral) house wire. Make sure all wire nuts are
secured. You may wrap the connections with electrical
tape. If your outlet box has a ground wire (green or
bare copper) connect fixtures ground wire to it.
Otherwise attach the bare copper fixture wire to the
green ground screw on the circular strap.
2. Tuck the wire connections neatly into the junction
box.
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
A
C
E
B
D
Fig.2
DOC20141202592
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
  • Page 1 1

Livex Lighting 2603-07 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI