Kichler Lighting 49899BKLED User manual

Brand
Kichler Lighting
Model
49899BKLED
Type
User manual
Date Issued: 09/28/17 IS-49899LED-US
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main
fusebox before starting and during the installation.
4) Make wire connections. Reference chart below for correct con-
nections and wire accordingly.
5) Carefullypushxture[5]towallmakingsurexturemounting
screws[2]passthroughxturemountingholes.
6) Make sure all connections remain secure and wires do not get
pinched.
7) Attachxture[5] to mounting plate using lock-up knobs[6].
INSTRUCTIONS FOR MOUNTING FIXTURE OUTDOORS
AND/OR IN WET LOCATIONS.
8) Mountingsurfaceshouldbeclean,dry,atand1/4”largerthat
thexturecanopyonallsides.Anygapsbetweenthemounting
surfaceandxturecanopyexceeding3/16”shouldbecor-
rected as required.
9) With silicone caulking compound, caulk the top and sides
whereedgeofxturecanopymeetsthewallsurfacetoprevent
waterfromenteringtheoutletbox.Thebottomofthexture
canopy should be left un-caulked.
WARNING:
Thisxtureisintendedforinstallationinaccordancewiththe
NationalElectricalCode(NEC)andalllocalcodespecications.
If you are not familiar with code requirements, installation by a
certiedelectricianisrecommended.
CLEANING:
Always be certain that electric current is turned off before cleaning.
Only a damp cloth should be used. Harsh cleaning products may
damagethenish.
FCC INFORMATION:
Thisdevicecomplieswithpart15oftheFCCRules.Operationis
subject to the following two conditions:
(1) Thisdevicemaynotcauseharmfulinterference,and
(2) thisdevicemustacceptanyinterferencereceived,including
interference that may cause undesired operation.
Note:Thisequipmenthasbeentestedandfoundtocomplywiththe
limitsforaClassBdigitaldevice,pursuanttopart15oftheFCC
Rules.Theselimitsaredesignedtoprovide
reasonable protection against harmful interference in a residential
installation.Thisequipmentgenerates,usesandcan
radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful
interferencetoradiocommunications.However,thereisno
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference
toradioortelevisionreception,whichcanbedeterminedby
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following mea-
sures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connect the equipment into an outlet on a circuit different from
thattowhichthereceiverisconnected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
INSTALLATION:
• Read and understand all instructions and illustrations com-
pletely before proceeding with assembly and installation of
xture.
• Ifyouhaveanydoubtsabouthowtoinstallthisxture,orifthe
xturefailstooperatecompletely,pleasecontactaqualied
electrician.
• All parts must be used as indicated in the instructions. Do not
substituteanyparts,leavepartsout,oruseanypartsthatare
wornorbroken.Failuretoobeythisinstructioncouldinvalidate
theULlisting,C.S.A.certication,and/orETLlistingofthisxture.
• Fixtureistobeconnectedtoasinglebranchcircuit.
• Mountingsurfaceshouldbeclean,dry,atand1/4”largerthan
thexturehousingsurface.
INSTRUCTIONS:
1) Findtheappropriatethreadedholesonmountingstrap[1]
andassemblexturemountingscrews[2] into threaded holes.
Makesurexturemountingscrews[2] line up with mounting
holesinxture[5].
2) Attach mounting strap[1]tooutletbox[3] using mounting
screws[4]
.Themountingstrapcanbeadjustedtosuitposition
ofxture,
3) Groundinginstructions:(SeeIllus.AorB).
A) Onxtureswheremountingstrapisprovidedwithahole
andtworaiseddimples.Wrapgroundwirefromoutletbox
around green ground screw, and thread into hole.
B) Onxtureswhereacuppedwasherisprovided.Attach
groundwirefromoutletboxundercuppedwasherand
green ground screw, and thread into mounting strap.
Ifxtureisprovidedwithgroundwire.Connectxtureground
wiretooutletboxgroundwirewithwireconnector.(Notpro-
vided.)Afterfollowingtheabovesteps.Neverconnectground
wire to black or white power supply wires.
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
A
B
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
1
2
3
4
5
6
Page is loading ...
  • Page 1 1
  • Page 2 2

Kichler Lighting 49899BKLED User manual

Brand
Kichler Lighting
Model
49899BKLED
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers