Whirlpool BF 3022 NF User guide

Type
User guide
GB
Operating Instructions
FREEZER
Contents
Installation, 10
Positioning and connection
Description of the appliance, 11
Overall view
Start-up and use, 12
Starting the appliance
Using the freezer to its full potential
Maintenance and care, 13
Switching the appliance off
Cleaning the appliance
Avoiding mould and unpleasant odours
Precautions and tips, 14
General safety
Disposal
Respecting and conserving the environment
Troubleshooting, 15
Assistance, 16
Italiano, 1 English, 9
GBI
BF 3022 NF
Portuges
, 25
P
Nederlands
, 17
NL
10
GB
Installation
! Before placing your new appliance into operation
please read these operating instructions carefully.
They contain important information for safe use, for
installation and for care of the appliance.
! Please keep these operating instructions for future
reference. Pass them on to possible new owners of
the appliance.
Positioning and connection
Positioning
1. Place the appliance in a well-ventilated humidity-free
room.
2. Do not obstruct the rear fan grills. The compressor and
condenser give off heat and require good ventilation to
operate correctly and save energy.
3. Ensure the appliance is away from any sources of
heat (direct sunlight, electric stove, etc.).
Electrical connections
After the appliance has been transported, carefully
place it vertically and wait at least 3 hours before
connecting it to the electricity mains. Before inserting
the plug into the electrical socket ensure the following:
The appliance is earthed and the plug is compliant
with the law.
The socket can withstand the maximum power of
the appliance, which is indicated on the data plate
located inside the freezer (e.g. 150 W).
The voltage is in the range of values indicated on the
data plate located inside the freezer (e.g. 220-240V).
The socket is compatible with the plug of the appliance.
If the socket is incompatible with the plug, ask an
authorised technician to replace it (see Assistance). Do
not use extension cords or multiple sockets.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be easily
accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced
by authorised technicians only (see Assistance).
! The manufacturer declines any liability should
these safety measures not be observed.
GB
11
Description of the
appliance
Overall view
The instructions contained in this manual are applicable to different model refrigerators. The diagrams may not
directly represent the appliance purchased.
SUPER FREEZE
Indicator light
POWER
Indicator light
SUPER FREEZE
Button
WARNING
Indicator light
TEMPERATURE
CONTROL Knob
FREEZER and
STORAGE
compartment
STORAGE
compartment
ICE tray
Varies by number and/or position.
STORAGE
compartment
12
GB
Start-up and use
Starting the appliance
! Before starting the appliance, follow the
installation instructions (see Installation).
! Before connecting the appliance, clean the
compartments and accessories well with lukewarm
water and bicarbonate.
! The appliance comes with a motor protection control
system which makes the compressor start
approximately 8 minutes after being switched on. The
compressor also starts each time the power supply is
cut off whether voluntarily or involuntarily (blackout).
1. Insert the plug into the socket and make sure that
the green POWER indicator light illuminates (the
TEMPERATURE ADJUSTMENT knob must be in the
OFF position).
2. Turn the TEMPERATURE ADJUSTMENT knob to an
average value and press the SUPER FREEZE
button (rapid freezing): the SUPER FREEZE
indicator light
will illuminate. It will switch off
once the freezer has reached its optimal
temperature. At this point food may be placed
inside the appliance.
Using the freezer to its full potential
Use the TEMPERATURE CONTROL knob to adjust
the temperature.
MIN = warmest MAX = coldest
is the optimal temperature for energy saving
levels.
We recommend, however, a medium position.
Do not re-freeze food that is defrosting or that has
already been defrosted. These foods must be
cooked and eaten (within 24 hours).
Fresh food that needs to be frozen must not come
into contact with food that has already been
defrosted. Fresh food must be stored in the
FREEZER and STORAGE compartment.
Do not place glass bottles which contain liquids,
and which are corked or hermetically sealed in the
freezer because they could break.
The maximum quantity of food that may be frozen daily is
indicated on the plate containing the technical properties
located within the freezer (for example: Kg/24h: 4).
To freeze (if the freezer is already operating):
- for small quantities which are less than those
indicated on the data plate, press the rapid freezing
SUPER FREEZE button (corresponding indicator light
illuminates), insert the food and close the door.
The function is disabled automatically after 24 hours
or when optimal temperatures have been reached
(indicator light goes out);
- for large quantities which are greater than the
maximum load indicated on the data plate, hold down
the rapid freezing SUPER FREEZE button until the
corresponding indicator light begins to flash. After 24
hours the indicator light stops flashing and remains on
constantly. Place the food inside the freezer and close
the door. After another 24 hours, the function will be
disabled automatically (indicator light goes out).
! Do not open the door during freezing.
! If there is a power cut or malfunction, do not open
the freezer door. This will help maintain the
temperature inside the freezer, ensuring that foods are
conserved for at least 9 -14 hours.
WATER LEVEL
MAX
WATER LEVEL
MAX
WATER LEVEL
MAX
ICE tray
The fact that they are situated on the top part of the
freezer drawers ensures greater cleanliness: the ice no
longer comes into contact with the food placed inside the
freezer compartment; furthermore, the dripping of the
water during filling is avoided (a lid to cover up the hole
after filling with water is also provided).
1. Pull out the tray by pushing it up.
Check that the tray is ompletely empty and fill it with
water through the opening provided.
2. Take care not to exceed the level indicated (MAX
WATER LEVEL). Excess water prevents the ice cubes
from dispensing (if this happens, wait for the ice to melt
and empty the tray).
3. Turn the tray 90°: due to the connected compartments
each mould fills with water (see diagram).
4. Close the opening with the lid provided and put the
tray back.
5. When the ice has formed (minimum time approximately
8 hours) knock the tray against a hard surface and wet
the outside so that the ice cubes come loose and take
them out through the opening.
GB
13
Maintenance and care
Switching the appliance off
During cleaning and maintenance it is necessary to
disconnect the appliance from the electricity supply:
1. set the TEMPERATURE CONTROL Knob on OFF;
2. pull the plug out of the socket.
! If this procedure is not followed, the alarm may
sound. This alarm does not indicate a malfunction. To
restore normal operation, turn the TEMPERATURE
ADJUSTMENT knob to the OFF position and then turn
it back to the desired value. To disconnect the
appliance, follow point 1 and 2.
Cleaning the appliance
The external and internal parts, as well as the
rubber seals may be cleaned using a sponge that
has been soaked in lukewarm water and
bicarbonate of soda or neutral soap. Do not use
solvents, abrasive products, bleach or ammonia.
The removable accessories may be soaked in
warm water and soap or dishwashing liquid. Rinse
and dry them carefully.
The back of the appliance may collect dust which
can be removed by delicately using the hose of a
vacuum cleaner set on medium power. The
appliance must be switched off and the plug must
be pulled out before cleaning the appliance.
Avoiding mould and unpleasant odours
The appliance is manufactured with hygienic
materials which are odour free. In order to maintain
an odour free refrigerator and to prevent the
formation of stains, food must always be covered or
sealed properly.
If you want to switch the appliance off for an
extended period of time, clean the inside and leave
the doors open.
14
GB
Precautions and tips
! The appliance was designed and manufactured in
compliance with international safety standards. The
following warnings are provided for safety reasons and
must be read carefully.
This appliance complies with the following
Community Directives:
- 73/23/EEC of 19/02/73 (Low Voltage) and
subsequent amendments;
-89/336/EEC of 03.05.89 (Electromagnetic
Compatibility) and subsequent amendments;
- 2002/96/CE..
General safety
The appliance was designed for domestic use inside the
home and is not intended for commercial or industrial use.
The appliance must be used to store and freeze food
products by adults only and according to the
instructions in this manual.
The appliance must not be installed outdoors, even in
covered areas. It is extremely dangerous to leave the
appliance exposed to rain and storms.
Do not touch the appliance with bare feet or with wet or
moist hands and feet.
WARNING: do not damage the refrigerant circuit.
Do not touch the internal cooling elements: this could
cause skin abrasions or frost/freezer burns.
When unplugging the appliance always pull the plug
from the mains socket, do not pull on the cable.
Before cleaning and maintenance, always switch off the
appliance and disconnect it from the electrical supply. It
is not sufficient to set the temperature adjustment knobs
on OFF (appliance off) to eliminate all electrical contact.
In the case of a malfunction, under no circumstances
should you attempt to repair the appliance yourself.
Repairs carried out by inexperienced persons may
cause injury or further malfunctioning of the appliance.
Do not use utensils other than the scraper provided, or
electrical equipment which is not of the type specified
by the manufacturer, inside the frozen food storage
compartments.
Do not put ice cubes taken directly from the freezer into
your mouth.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
lack of experience and knowledge unless they have
been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Keep packaging material out of the reach of children! It
can become a choking or suffocation hazard.
Disposal
Observe local environmental standards when
disposing packaging material for recycling
purposes.
The European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances
must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be
collected separately in order to optimise the
recovery and recycling of the materials they contain
and reduce the impact on human health and the
environment. The crossed out wheeled bin
symbol on the product reminds you of your
obligation, that when you dispose of the appliance
it must be separately collected.
Consumers should contact their local
authority or retailer for information
concerning the correct disposal of their old
appliance.
Respecting and conserving the
environment
Install the appliance in a fresh and well-ventilated
room. Ensure that it is protected from direct sunlight
and do not place it near heat sources.
Try to avoid keeping the door open for long periods
or opening the door too frequently in order to
conserve energy.
Do not fill the appliance with too much food:
cold air must circulate freely for food to be
preserved properly. If circulation is impeded, the
compressor will work continuously.
Do not place hot food directly into the refrigerator.
The internal temperature will increase and force the
compressor to work harder and will consume more
energy.
Regularly check the door seals and wipe clean to
ensure they are free of debris and to prevent cold
air from escaping (see Maintenance).
GB
15
Troubleshooting
If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list.
Malfunctions:
The green POWER indicator light
does not illuminate.
The motor does not start.
The ALARM indicator light
is
illuminated and the buzzer sounds at
regular intervals.
The ALARM indicator light
is
flashing and the buzzer sounds at
regular intervals.
Possible causes / Solutions:
The plug has not been inserted into the electrical socket, or not far
enough to make contact, or there is no power in the house.
The appliance comes with a motor protection control (see Start-up and use).
a) The temperature in the freezer is too high. Check the quality of the food
products and dispose if necessary.
b) The temperature in the freezer has reached a dangerous level. The
food must be disposed immediately.
a/b) In both these cases the freezer will maintain a certain temperature so
that the food does not re-freeze.
To restore normal operation bring the TEMPERATURE CONTROL
knob setting to OFF and turn the appliance on again.
The door has been opened too frequently.
The ALARM indicator light
The TEMPERATURE CONTROL knob is not in the correct position.
remains illuminated constantly.
The SUPER FREEZE button has been pressed: the yellow FAST
The motor runs continuously.
FREEZE indicator light is on (see Description).
The door is not closed properly or is continuously opened.
The outside ambient temperature is very high.
The appliance has not been installed on a level surface (see
The appliance makes a lot of noise.
Installation).
The appliance has been installed between cabinets that vibrate and
make noise.
The internal refrigerant makes a slight noise even when the compressor
is off. This is not a defect, it is normal.
The appliance is not operating correctly. Contact the Technical Assistance
The green POWER indicator light
Centre.
is flashing.
16
GB
Assistance
Before calling for Assistance:
Check if the malfunction can be solved on your own (see Troubleshooting).
If after all the checks, the appliance still does not operate or the problem persists, call the nearest Service
Centre
Communicating:
type of malfunction
appliance model (Mod.)
serial number (S/N)
This information can be found on the data
plate located on the bottom left side of the
refrigerator compartment.
Never call on unauthorized technicians and always refuse spare parts which are not originals.
model
serial number
195083133.02
11/2011
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32

Whirlpool BF 3022 NF User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI