Instruction Manual
Heated Throw Blanket - BHR180
General Safety 4
Product Overview 7
Positioning 8
Operation 8
Cleaning & Maintenance 9
Washing Instructions 9
Machine Wash 9
Hand Wash 9
Drying 9
Stretching 9
Specifications 10
Customer Helpline Last Page
CONTENTS
4
Read this manual thoroughly before you start using the product.
Store this manual, the completed warranty card, your receipt and the product packaging.
The safety precautions instructions reduces the risk of fire, electric shock and injury when
correctly complied to. Please follow all instructions and take notice of all warnings.
• The Heated Throw Blanket should be examined frequently for signs of wear, either of
the Heated Throw Blanket, controller or flexible cord.
• If the Heated Throw Blanket or its power cord is damaged, unplug and stop using it
immediately and then contact customer support.
• Check that your electric throw blanket is not damaged before switching it on.
• Always unfold or unroll before switching on.
- Failure to observe these instructions will result in overheating. This will
activate the overheat safeguard system, thus leaving the Heated Throw Blanket
inoperative.
- Misuse of this Heated Throw Blanket will invalidate your warranty.
• When storing the Heated Throw Blanket, allow it to cool down before folding it.
Fold neatly but not tightly (or rolled) without sharp bends in the heating elements and
store where no other heavy objects will be placed upon it.
• The Heated Throw Blanket should not be used on an adjustable bed. However, if the
Heated Throw Blanket is used on an adjustable bed, check that the Heated Throw Blanket
and cord do not become trapped or rucked, for example, in hinges.
• The Heated Throw Blanket is not to be used by very young children (0-3 years).
• The Heated Throw Blanket is not to be used by young children over the age of three
unless the controls have been pre-set by a parent or guardian or unless the child
has been adequately instructed on how to operate the controls safely.
• This Heated Throw Blanket is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
• This Heated Throw Blanket must not be used by persons insensitive to heat and
other very vulnerable persons who are unable to react to overheating.
• It is recommended that persons with artificial pacemaker should check with their
doctor and the manufacturer of the pacemaker before using this Heated Throw Blanket.
• Heated Throw Blankets are intended for human use only. Not for animals and pets.
• Do not allow pets or animals to lie or chew on this product or on the electrical cords
etc. Prolonged application at the highest heat setting can result in skin burns.
• Keep the control away from open windows.
GENERAL SAFETY
5
• Children being supervised not to play with the appliance.
• Used only with detachable devices marked on the appliance.
• Do not crease the appliance by placing items on top of it during storage.
• Not intended for medical use in hospital
• Keep the controller/s away from external heat sources, i.e. a heater, fireplace etc.
• Do not use pins as these may damage the electric wiring.
• The flexible supply cord and switch must, as far as practicable, be kept outside of
the Heated Throw Blanket. Do Not Cover the Controller.
• Do not switch the power on if the Heated Throw Blanket is wet or in a folded state.
• Switch o and unplug from power when the electric throw blanket is not in use.
• Do not leave heavy objects on the bed, e.g. folded Heated Throw Blanket,
suitcases etc. when the Heated Throw Blanket is switched on as this will trigger the
over temperature device and render the Heated Throw Blanket PERMANENTLY
inoperable. This may also invalidate the warranty.
• Do not dry-clean this Heated Throw Blanket. Cleaning liquid may have a damaging
eect on the insulation covering of the heating element. Follow washing directions
located on the Heated Throw Blanket’s rating label and in this guide.
• This electric throw blanket is not to be used continuously
• When not using the unit for long periods of time or when you are moving the unit
please ensure to disconnect the power supply from the wall socket.
• Please ensure to contact our call center for any repair or service required for the products
not doing so will make warranty on your product void.
• We assume no liability for any eventual damages to property or injury to persons caused
by misuse of the product or noncompliance with these instructions.
• This Heated Throw Blanket is not to be used in Bed or while Asleep.
• The Heated Throw Blanket must not be used over or under a water bed.
• This Heated Throw Blanket is for domestic use only. It is not intended for use in
hospitals or the like.
• Only use the controllers supplied with this Heated Throw Blanket.
• For additional protection, it is strongly recommended that the use of a residual
current device (ROD) with a tripping current not exceeding 30mA be used on the
circuit supplying this product. If you are unsure if your home has this device, please
contact your nearest Electrical Contractor.
• Always treat Electrical Appliances with the upmost care. Do not use this product in
any other fashion or for any other purpose other than stated in these instructions.
GENERAL SAFETY INSTRUCTIONS (Cont.)
6
GENERAL SAFETY INSTRUCTIONS (Cont.)
Please make sure upon positioning this product, the place is:
• Not wet or damp and Well ventilated
• Away from direct sunlight or heaters.
• Do not place containers with liquids, if liquid falls inside the products it may result in
short-circuit, fire or electric shock.
• Do not place small metallic objects on top of the unit or block the openings as it will
reduce operating eciency of the air con with failures or damages.
• The appliance shall under no circumstances, be covered with insulating material
or similar material.
• The blanket must not be located immediately below a socket outlet.
• Do not use this blanket in the immediate surrounding of a bath, shower or a
swimming pool.
• Close supervision is necessary when any appliance is used by or near children. Cleaning
and user maintenance shall not be made by children without supervision.
DO NOT INSTALL/USE THE APPLIANCE IN THE FOLLOWING AREAS:
- outdoors or where water is likely to splash
- near a bath, shower, laundry basin or swimming pool
- in an area where oil is likely to splash
- near a hot gas or electric burner, or sources of fire
- near sources of heat, or exposed to direct sunlight
- in the presence of flammable substances or vapour such as alcohol, insecticides,
petrol, etc.
- at a dry cleaner’s premises.
WARNING:
• Do not expose the appliance to high heat, sparks and open flames.
• Do not pierce or burn the appliance.
• Maintenance must only be carried out by properly qualified, authorised personnel.
If the appliance requires maintenance or service, contact our after sales support
centre info@ayonz.com
• Away from splashes or food.
• Protected from excessive dust or grease.
7
PRODUCT OVERVIEW
8
POSITIONING
OPERATION
PLACING OF BLANKET
Your blanket is designed to be used as over blanket or wrap
1 Spread the blanket out over yourself while lying in the bed or sitting on the sofa.
2 The blanket may be wrapped around you but don’t folded, do not sit on the blanket or
wrap very tightly when blanket is turned on.
This may lead to the overheat protection system being activated. please choose “4”
heat settings for wrap use.
3 When the blanket is in use, ensure the connecting plug remains on the upper surface.
4 Make sure your blanket is unfolded when you remove youself from it but while blanket is
turned on.
5 To avoid any skin injury and ensure blanket longevity, please chose “4” heat settings for
normal use.
USING YOUR BLANKET
You can program your blanket to work for 1-9 & 12 hours and 1-9 heat settings
1. Plug into the mains power supply and switch on the socket. 2m main cable ensure the
plug can reach your socket.
2. Switch on the blanket with “0/1” buttons
3. LED for timer and temp will be lit, adjust buttons mark “Timer” and “Temp” to your
preferable settings
4. When LED shows” H” , it means 12 hours timer
NOTE: This will assist in drying out any moisture which has been accumulated. You may
notice and odour when using the blanket for the first time, due to the insulation material.
This is harmless and will subside quickly. The highest temp 9 can be used only for preheat
1 hour and not for continuous operation, We recommended that preset 4 for whole night
use. Original setting for the control is 1 hour timer and 0 heat setting
9
THE BLANKET IS SUITABLE FOR WASHING BUT MUST NEVER BE DRY CLEANED
WASHING INSTRUCTIONS
1. PRIOR TO WASHING DISCONNECT TO LEAD
FROM HEAT CONTROL. ENSURE HEAT
CONTROLLER DO NOT IMMERSE IN ANY LIQUID.
2 BEFORE WASHING THE BLANKET, IT IS ESSENTIAL
THAT YOU MEASURE IT AND ENSURE IT IS
STRETCHED TO APPROXIMATELY ITS ORIGINAL
SIZE DURING THE DRYING PROCESS.
3 SPIN DRY ON SOFT PROGRAMME ONLY. DO NOT
USE AN EXTRA SPIN CYCLE
4 DO NOT MACHINE DRY, DO NOT IRON.
MACHINE WASH
MAX 40 Degrees temperature. Must be washed on a gentle
wash program 40°C or less Temp.
HAND WASH
1 Use a mild washing powder or detergent and luke warm water to soak your blanket for
15 minutes. After soaking, gently wash the blanket through and rinse thoroughly with
fresh, luke warm water.
2 Allow the excess water to drain from the throw, it may also be gently squeezed,
but never wring the blanket.
DRYING
Air dry on a clothes line, but do not use clothes pegs on the wired area of the throw as the
may damage wires.
- DO NOT DRY WITH A HAIR DRYER OR HEATER
- DO NOT USE YOUR THROW UNTIL IT IS COMPELETLY DRY
STRETCHING
1 The blanket must be stretched back to approximately its original size during the drying
process. This is best done while damp. Working from side to side, stretching a strip at a
time. This procedure may need to be repeated a few times until fully dry
2 Inspect the blanket to ensure that one of the wires have formed loops or become
twisted back on themselves. Holding the blanket up to the light will make it easier to
inspect the wires.
3 If any problems with the wires persist after the stretching process, or the blanket does
not return to close to its original side, return it along with the controller to Service centre
for a safety inspection.
CLEANING & MAINTENANCE
10
SPECIFICATIONS
Rating 220-240V ~ 50Hz, 100W
Weights
NET 1.5 kg
GROSS 2 kg
Dimensions 1600 (w) × 1200 (d) × 30 (h)
STORAGE
When not in use and you prefer to store the blanket, allow it to cool down before folding.
- DO NOT place heavy items on top of the blanket when in storage, as this may damage
the wiring.
- DO NOT use any moth proofing chemicals
11
CUSTOMER HELPLINE:
info@ayonz.com
DISTRIBUTED BY:
Ayonz Pty Ltd
/