Technoflex Secure Parking Curbs Owner's manual

We recycle for a better world

www.technoflex.ca

How to install parking curbs?

I. Drill holes into the asphalt through the holes already in the rubber parking

curb. Make sure the holes are at least ½ inch wide and 3-4 inches deep.

II. Drive the ½ inch rebar spike through the holes in the rubber parking curb.

Rebar Spikes should be 14 inches long.

III. Leave the rubber parking curb undisturbed for a minimum of 12 hours.

Rubber parking curbs do not require maintenance; however, it is advised

to periodically check the spikes to see if they have come up. If they have,

make sure to keep them hammered down below the surface of the parking

curb.

This manual is also suitable for