2. Computers & electronics
  3. Networking
  4. Telephone switching equipment
  5. Patch panels
  6. Primex
  7. Patch Panels

Primex Patch Panels, CAT6A Patch Panels 12-24-48 Port Installation guide

  • I have reviewed the installation instructions for the PRIMEX STAR19110C6-12 12-Port Cat6 Patch Panel. This document details the steps for mounting, wiring, and managing cables for the patch panel, including specific wiring diagrams for T568A and T568B configurations. I'm ready to help answer any questions you have about its installation or features.
  • How much cable jacket should I strip?
    How far should I untwist wire pairs?
    What tool is required to terminate the wires?
    What wiring configurations are supported?
    Where can i route cables?
Fit everything. Together.
FOR MORE INFORMATION CONTACT:
T
1.604.881.7875 F 1.604.881.7835
www.primex.com
PRIMEX
Installation Instructions
WIRING DIAGRAMS
INSTRUCTIONS
1. Strip cable jacket approximately 1-1/2”.
Insert wires into IDC according to the de-
sired wiring configuration (T568A/T568B).
Do not untwist wire pairs more than 1/2”
from termination point.
2. Terminate wires using an impact tool; make
sure excess wires are trimmed off.
3. Loosely bundle and secure cables to the
wire management bracket with zip ties.
1. Mount bracket to wall.
2. Attach panel to bracket with IDC’s facing
out to dress and terminate wires. Then
turn panel around and attach to panel
with jack openings facing out.
Route cables from bracket through top,
bottom or sides.
12-Port Cat6 Patch Panel
STAR19110C6-12 Installation Instructions
BROWN
WHITE/BROWN
GREEN
WHITE/GREEN
ORANGE
WHITE/OR
ANGE
BLUE
WHITE/BLUE
87 21 63 45
T568A WIRING
BROWN
WHITE/BROWN
ORANGE
WHITE/ORANGE
GREEN
WHITE/GR
EEN
BLUE
WHITE/BLUE
87 21 63 45
T568B WIRING
1
1
2
3
2
/