2. Bante Instruments
  3. IE-50T Industrial Conductivity Electrode

Bante Instruments IE-50T Industrial Conductivity Electrode Owner's manual

  • Hello! I've reviewed the user guide for the Bante Instruments Industrial Conductivity Electrodes, models IE-50MT, IE-50LT, and IE-50HT. This document outlines the specifications, installation, and maintenance of these devices, which measure conductivity and temperature in aqueous solutions. I'm here to help you with any questions you might have about these electrodes.
  • What is the operating temperature range for the electrodes?
    What is the maximum process pressure for the electrodes?
    What is the standard electrode cable length?
    What are the conductivity measurement ranges for the different models?
This electrode is designed for the measurements of the conductivity and temperature in aqueous solution and is suitable
for continuous use in process applications.
Overview
Specifications
Model
IE-50MT IE-50LT IE-50HT
Range
10 µ S/cm to 20 mS/cm 0 to 100 μS/cm 0.1 to 200 mS/cm
Temperature Sensor
NTC 10 KΩ
Operating Temperature
0 to 80° C (32 to 176° F)
Maximum Process Pressure
0.6 MPa (87 PSIG)
Body Type
Stainless steel 316L/PC
Electrode Diameter
13 mm (0.51 in.), with 3/4 in. NPT thread at ends
Standard Electrode Cable Length
5 m (16.4 ft.)
Maximum Transmission Distance
30 m (98.4 ft.)
IE-50T
Industrial Conductivity Electrode I User Guide
Electrode Dimensions
Ø 13 mm (0.51")
Ø 26 mm (1.02")
Connections
1 Red wire: conductivity measurement ( + )
2 Black wire: conductivity measurement ( − )
3 Green wire: temperature ( + )
4 Yellow wire: temperature ( − )
60 mm (2.36")
IE-50T
Installation
Selectable Mounting Positions
The arrow represents the direction of the liquid flow.
Installing the Electrode
1. Wrap Teflon tape to the electrode body threads.
2. Insert the electrode into the mounting position and slowly turn clockwise until secure. Hand tighten the
electrode to prevent liquid leakage.
DO NOT immerse the electrode into liquid completely, the cable is not waterproof.
Electrode Maintenance
In order to maintain an accurate measurement value, the electrode needs cleaning and regular maintenance, cleaning
procedure is as follow.
1. Remove electrode from service and soak the electrode for about 30 minutes in detergent to remove dirt and oil
stains on the electrode.
2. Rinse the electrode with clear water and calibrate electrode according to instructions in the controller manual.
Reinstall the electrode.
Optional Accessories
Order code
Description
ECCS-84
Conductivity standard solution 84 µ S/cm, 480 ml
ECCS-1413
Conductivity standard solution 1413 µ S/cm, 480 ml
ECCS-1288
Conductivity standard solution 12.88 mS/cm, 480 ml
Bante Instruments Inc. I banteinstruments@yahoo.com I www.bante-china.com
/