HAMPTON 2ANTY-B0008 User manual

Brand
HAMPTON
Model
2ANTY-B0008
Type
User manual

HAMPTON 2ANTY-B0008 is a dimmable LED lamp with Wi-Fi signal control, suitable for indoor, residential, and commercial lighting. It operates on a stable power supply with a wide voltage range of AC120V 60Hz and should not be used in emergency lights, where water may drop on the lamp, or in airtight lamp fixtures. The lamp is not intended for emergency exit fixtures or lights and should not be disposed of as unsorted municipal waste. It should be recycled at an authorized place for electrical and electronic appliances.

HAMPTON 2ANTY-B0008 is a dimmable LED lamp with Wi-Fi signal control, suitable for indoor, residential, and commercial lighting. It operates on a stable power supply with a wide voltage range of AC120V 60Hz and should not be used in emergency lights, where water may drop on the lamp, or in airtight lamp fixtures. The lamp is not intended for emergency exit fixtures or lights and should not be disposed of as unsorted municipal waste. It should be recycled at an authorized place for electrical and electronic appliances.

User Manual
Before using self-ballasted LED lamp please read the safety instructions carefully
Can use on a stable source of voltage that fluctuates in wide range AC120V 60Hz
Always turn off the switch when replacing or cleaning the lamp. Remove and install it bygrasping
only the plastic portion of the lamp.
This product can replace incandescent lamp to use in indoor, residential and commercial lighting
Never use in the following conditions
1 Power supply with low voltage DC such as emergency light
2 Where water may drop on the lamp
3 Unsuitable for application when the lamp must turn on and off frequently
4 Do not use in moist spot and airtight lamp fixture
5 This device is not intended for use with emergency exit fixtures or emergency exit lights
This product must not be disposed together with the domestic waste. This product has to be disposed
at an authorized place for recycling of electrical and electronic appliances.
By collecting and recycling waste, you help save natural resources, and make sure the product is
disposed in an environmental friendly and healthy way.
DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of such waste
separately for special treatment is necessary.
This is WIFI signal contorl dimmable LED Lamp. Please do not use any dimmer.
“For lamps with a weight significantly higher than that of the lamps for which they are a
replacement, attention should be drawn to the fact that the increased weight may reduce
the mechanical stability of certain luminaires and lampholders and may impair contact
making and lamp retention.”
Use in Dry Locations only
The light source contained in this lamp shall only be replaced by the manufacturer or his service
agent or a similar qualified person.
For lamps with a weight significantly higher than that of the lamps for which they are a replacement,
attention should be drawn to the fact that the increased weight may reduce the mechanical stability of
certain luminaires and lampholders and may impair contact making and lamp retention.
Product name: LED LAMP
Model name: 2ANTY-B0008
FCC ID: 2ANTYB0008
IC: 26025-B0008
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
IC Warning
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
IC Radiation Exposure Statement
This product complies with IC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter. This modular must be installed and operated with a
minimum distance of 20 cm between the radiator and user body.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement
Déclaration de rayonnement IC
Ce complies avec des radiations émettrices de rayonnement Environnement. Ceci ne doit
pas être co-localisé ou opérer avec des autres Ce modular doit être installé et obtenu
avec une distance minimale de 20 cm entre les radiateurs et le corps de l’utilisateur.
This product complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter. This modular must be installed and operated with a minimum
distance of 20 cm between the radiator and user body.
FCC Radiation Exposure Statement
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
  • Page 1 1
  • Page 2 2

HAMPTON 2ANTY-B0008 User manual

Brand
HAMPTON
Model
2ANTY-B0008
Type
User manual

HAMPTON 2ANTY-B0008 is a dimmable LED lamp with Wi-Fi signal control, suitable for indoor, residential, and commercial lighting. It operates on a stable power supply with a wide voltage range of AC120V 60Hz and should not be used in emergency lights, where water may drop on the lamp, or in airtight lamp fixtures. The lamp is not intended for emergency exit fixtures or lights and should not be disposed of as unsorted municipal waste. It should be recycled at an authorized place for electrical and electronic appliances.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents