TEXET CC3L-DT is a cross-cut shredder intended for private/domestic and small office use. It can shred up to 2 vertically folded A4 sheets of 70gsm paper at once and will accept paper width up to 110mm. When shredding smaller items like envelopes or credit card receipts, it’s best to insert them through the middle of the feed slot. It also shreds Credit Cards, one at a time, but always at the start of the duty cycle and not at the end, as the motor may overheat and stop.
TEXET CC3L-DT is a cross-cut shredder intended for private/domestic and small office use. It can shred up to 2 vertically folded A4 sheets of 70gsm paper at once and will accept paper width up to 110mm. When shredding smaller items like envelopes or credit card receipts, it’s best to insert them through the middle of the feed slot. It also shreds Credit Cards, one at a time, but always at the start of the duty cycle and not at the end, as the motor may overheat and stop.
SPECIFICATION
Model:
CC3L-DT
Voltage:
220-240VAC,50Hz
Current:
0.7A
Paper entry width:
110mm
Shred size:
5mm x 28mm
Shred paper capacity:
2 Folded A4 Sheets 70gsm
Shred speed:
3.0 Mtrs/Min
Waste bin Volume:
3L
Noise level:
72.0db
Duty cycle:
2 Mins On/60Mins Off
Net weight:
1.2Kgs
Dimension:
175 x 130 x 200mm
Type designation:
BS60950-1:2006
EMC Directive 2004/108/EC
Test Standards:EN55014-1:2006
EN55014-2:1997+A1:2001
EN61000-3-2:2006
EN61000-3-3:2008
Visit www.texet.com for details on other Texet products.
UK: Waste Electrical products/batteries should not be disposed of with household waste.
Separate disposal facilities exist, for your nearest facilities, see www.recycle-more.co.uk
or in store for details.
Made in China
Instruction Manual
CROSS CUT SHREDDER
CC3L-DT
Please read the following Instructions carefully before use and keep for future reference.
Thank you for purchasing the TEXET Cross Cut Shredder CC3L-DT, with normal use and
maintenance, your shredder will provide years of satisfactory performance.
To protect this Shredder correctly and avoid any damage, please
ensure you understand the following Icons:-
Please keep clothes, ties and the like away from the paper entry slot.
To prevent damage to the cutters remove paper clips, and other
fasteners before shredding.
Please keep your hands out of the paper entry slot as the sharp blades
may cause injury.
Please keep your hair away from the shredder/paper entry slot.
Please keep children away from the Shredder, the sharp blades may harm
them.
Please do not spray any flammable gas, water or oil onto this Shredder.
The incorrect operation of this appliance may cause personal injury or damage the shredder.
The Plug Socket outlet should be easily accessible. BS Plug 3A Fuse fitted.
GENERAL SAFETY
When using electrical appliance, basic precautions should always be followed to reduce the
risk of fire, electrical shock and injury to persons including the following;
The Shredder is only intended for private/domestic and small office use. Any other uses not
recommended by the manufacture, may result in the warranty being void.
Do not use the shredder to shred film, OHP Pouches, adhesive stickers, or any plastics, other
that credit cards, as these may cause damage.
Remove the Shredder from its packaging and check to make sure it is in good condition before
using. Keep the packaging for storage and transportation.
This Shredder is not intended for use by persons, including children, with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the Shredder by a person responsible
for their safety.
Extreme caution is necessary where children or persons with reduced physical, sensory or
mental capabilities may come into contact with the Shredder when in use.
Do not let children play with parts of the packaging, such as plastic bags.
Ensure the power supply to the socket into which the Shredder is plugged, is in accordance
with the rating label on the shredder and that the socket is earthed.
Do not use the Shredder if the Power Cord is damaged. If the Power Cord is damaged it must
be replaced by a recognized service agency or other qualified person.
Always turn the Power off before unplugging the Shredder and make sure your hands are dry
to prevent electric shock.
Always unplug the Shredder when not in use.
Setting the Shredder up:
Remove the shredder from the Gift Box.
Place the shredder head onto the waste bin. The shredder head is fitted with a safety
switch, (located underneath the shredder head), which needs to sit on top of the
plastic rib that is located on the inside of the Waste Bin, (right hand side).
The shredder needs to be placed on a flat stable surface.
Shredder Capacity:
The CC3L-DT will shred 2 vertically folded A4 sheets of 70gsm paper at once and will accept
paper width up to 110mm. When shredding smaller items like envelopes or credit card
receipts, it’s best to insert them through the middle of the feed slot. The Shredder will shred
Credit Cards, one at a time. Always shred credit cards at the start of the duty cycle and not at
the end, as the motor may overheat and stop.
Operating the Shredder:
Prepare the paper to be shredded by removing paper clips, and any other objects or
fasteners that may jam in the feed slot or damage the blades.
Only feed 2 vertically folded sheets of 70gsm A4 paper into the paper entry slot, at
any one time, otherwise it may overload the shredder.
Move the control switch to the FWD position and feed the folded paper into the
paper entry slot. When you have finished shredding the paper, move the switch to
the OFF position, (shredder does not have an automatic stop and start).
FWD: When you want to start shredding move the control switch to the FWD position, the
blades will now starting turning and paper can be shredded. Once you have finish shredding
move the switch to the OFF position.
OFF: This position is recommended when emptying the shredder bin or when the shredder is
not in use for a prolonged period of time.
REV: Reverses the shredding direction and backs items out of the shredder in the event of a
paper jam. Can also be used in conjunction with the FWD function to remove any paper
jammed in the blades.
Overheating.
The CC3L-DT is equipped with a motor overload protection device if the shredder overheats.
This means if the shredder is used for longer than the normal duty cycle, which is 2 minutes
on & 60 minutes off, the power will automatically switch off as the motor will need to cool
down.
In the event that this happens you need to unplug the power cord from the mains socket and
wait at least 60 minutes for the overload protection to reset.
After 60 minutes of cooling down, plug the Shredder back into the mains socket. If any paper
is still stuck in paper entry slot, move the control switch to the REV position and remove the
excess paper, then move the switch to FWD, this will clear any paper still left in the blades.
The shredder is now ready for use.
Clearing the Blades of Paper Jams
If paper becomes jammed during shredding, move the control switch to REV and remove any
excess paper from the feed slot. Move the switch back to OFF and see if this has cleared the
jam. If not move the switch between the FWD and REV 2-3 times and this should clear the
paper jam, (you may need to remove jammed paper from the blades and don’t forget to
unplug the shredder from the mains socket first).
ALWAYS UNPLUG THE SHREDDER BEFORE ATTEMPTING TO MANUALLY REMOVE AN ITEM
FROM THE PAPER ENTRY SLOT OR THE BLADES.
DO NOT, UNDER ANY CIRCUMSTANCES, INSERT METAL OBJECTS INTO THE PAPER ENTRY
SLOT OR THE BLADES, TO REMOVE THE JAMMED PAPER.
Maintenance.
When you want to maintain the shredder, please make sure you have switched off the
shredder and removed the plug from the mains socket.
Use a dry soft cloth to clean the shredder.
The shredder and waste bin are made of plastic; therefore please do not use solvents,
thinners or any abrasive pads/cloths, to avoid fading or scratches.
Do not allow water to enter the shredder head when cleaning.
To maintain the quality of your shredder blades, please use lubricating sheets/oil once a
month.
Waste Bin:
When you empty the waste bin, please make sure the shredder is switched off and
unplugged.
Place the shredder head back onto the bin correctly.
Tips: (To prevent paper jams).
Never shred more than 2 folded sheets at once.
Although the Waste Bin holds 20 A4 Sheets of shredded paper, the shredded paper can
become jammed in the blades, if you exceed this amount. To prevent this from
happening, we suggest you empty the bin every 10-12 sheets.
When shredding paper, always leave a few seconds gap between the shredding of the
last sheet/s and the shredding of the next sheet/s. This is to ensure that the previous
sheet has been fully shredded and the blades are completely paper free.
Once you have finished shredding paper, move the switch between REV and FWD
several times. This will clear any shredded paper still remaining in the blades, ensuring
the shredder blades will be clear and paper free, ready for the next time you use it.
TROUBLE SHOOTING
Troubles
Reason
Solution
Shredder does
not work after
paper is
inserted.
1. The power cord may not be
properly connected.
2. The motor has over heated.
3. The paper feed may be
jammed.
4. Shredder head is not
placed properly on basket.
1. Check the power cord is correctly
plugged into main socket.
2. Wait for at least 60 minutes and try the
shredder again.
3. Reverse the paper feed and remove
any jammed paper, then try again.
4. Place shredder head securely on
basket, correctly front facing, ensuring
contact with the basket is made.
Shredder
makes a high
noise
1. The shredder may not be
placed on a flat/stable
surface.
1. Replace the shredder onto a flat/stable
surface.
Shredder does
not shred
paper
1. Too much paper is
inserted.
2. The paper size inserted
may be larger than the paper
entry.
3. The paper may be inclined
when placed into the paper
entry.
1. Check to see if you have exceeded the
rated capacity of paper (2 vertically
folded sheets of 70 g).
2. Reverse the shredder and take out the
paper, fold in half and try again.
3. Re-insert the paper vertically.
-
1
-
2
-
3
-
4
TEXET CC3L-DT is a cross-cut shredder intended for private/domestic and small office use. It can shred up to 2 vertically folded A4 sheets of 70gsm paper at once and will accept paper width up to 110mm. When shredding smaller items like envelopes or credit card receipts, it’s best to insert them through the middle of the feed slot. It also shreds Credit Cards, one at a time, but always at the start of the duty cycle and not at the end, as the motor may overheat and stop.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
