Encryption: Usually this will simply be WPA-PSK(TKIP).
This can vary depending on how the WiFi network was set
up at your location
Attaching the 805W to your WiFi network
Click the “Wireless Settings” link at the left of the screen
SSID:
1. Type in the name of your WiFi SSID
2. Your WiFI SSID may simply be something similar
to” Linksys” or “Netgear”
3. Remember, the SSID is Case Sensitive
NetWork Mode: Make sure this setting is INFRA (STA)
Key Format: 1. Change From HEX to ASCII
2. If you do not change this setting, you will
get an error
3. See section “Setting up the printer’s IP
address –Problems / Solutions”
Encryption key: Change this to the password that was set up
for your WiFi network
Press the SUBMIT button
The screen may reload after pressing the submit button.
The
submit key just saves your current settings