AUSTRALIAN MONITOR AMIS HE2 Introduction

AMISHE2

Dual Channel Hum Eliminator

Introduction

The Australian Monitor Installation Series HE2 hum eliminator is a low cost

tool for eliminating hum & signal noise caused by ground loops. The AMIS

HE2 provides two discreet signal paths via balanced XLR inputs & outputs.

The AMIS HE2 is a passive device & can also be used as a converter of

balanced & unbalanced signals. As part of the AMIS Contractor Tools

range, the AMIS HE2 is an inexpensive hum eliminator that has a multitude

of uses in a wide variety of installations.

Description

• Inputs: This balanced XLR input receives signal from a mic or other

source.

• Output: This XLR output provides a transformer isolated output of the

input signal feed.

Specifications

Frequency Response: 10Hz-50kHz

THD: <.01% @ 1kHz

Insertion Loss 4dB @ 100K ohm load

Dimensions: 113mm x 75mm x 40mm