Cabletron Systems IA1100 Getting Started Manual

Internet Appliance 1100/1200

Getting Started Guide

Order No. 9033368

Part No. 39-193-01, Rev. 0A

Changes

Cabletron Systems, Inc., reserves the right to make changes in specifications and other information

contained in this document without prior notice. The reader should in all cases consult Cabletron

Systems, Inc., to determine whether any such changes have been made.

The hardware, firmware, or software described in this manual is subject to change without notice.

Disclaimer

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT,

SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED

TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION

CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR

SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

Copyright

Cabletron Systems, Inc.

35 Industrial Way

Rochester, NH 03867-5005

Printed in the United States of America

Trademarks

AppleTalk is a registered trademark of Apple Computer, Inc.

Cabletron Systems is a registered trademark and Cabletron, SmartSwitch, and GIGAswitch are

trademarks of Cabletron Systems, Inc.

Catalyst and EtherChannel are registered trademarks of Cisco Systems, Inc.

DEC is a registered trademark and Decnet is a trademark of Digital Equipment Corporation.

All other product names mentioned in this manual may be trademarks or registered trademarks of

their respective companies.

Regulatory Compliance Information

Internet Appliance 1100/1200 Getting Started Guide iii

Regulatory Compliance Information

This product complies with the following:

Safety

UL 1950; CSA C22.2, No. 950; 73/23/EEC; EN 60950; IEC 950

Electromagnetic

FCC Part 15; CSA C108.8; 89/336/EEC; EN 55022; EN 61000-3-2

Compatibility (EMC)

EN 61000-3-3; EN 50082-1, AS/NZS 3548; VCCI V-3

Regulatory Compliance Statements

FCC Compliance Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial environment.

This equipment uses, generates, and can radiate radio frequency energy and if not installed in

accordance with the operator’s manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause interference in which case the user

will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device that are not expressly approved by the

party responsible for compliance could void the user’s authority to operate the equipment.

Industry Canada Compliance Statement

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital

apparatus set out in the Radio Interference Regulations of the Canadian Department of

Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables

aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique

édicté par le ministère des Communications du Canada.

Regulatory Compliance Statements

iv Internet Appliance 1100/1200 Getting Started Guide

NOTICE: The Industry Canada label identifies certified equipment. This certification means that the

equipment meets telecommunications network protective, operational, and safety requirements as

prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The

department does not guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the

facilities of the local telecommunications company. The equipment must also be installed using an

acceptable method of connection. The customer should be aware that compliance with the above

conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be coordinated by a representative designated by the supplier.

Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give

the telecommunications company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power

utility, telephone lines, and internal metallic water pipe system, if present, are connected together. This

precaution may be particularly important in rural areas. CAUTION: Users should not attempt to

make such connections themselves, but should contact the appropriate electric inspection authority, or

electrician, as appropriate.

NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device provides an

indication of the maximum number of terminals allowed to be connected to a telephone interface. The

termination on an interface may consist of any combination of devices subject only to the requirement

that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.

VCCI Compliance Statement

This is a Class A product based on the standard of the Voluntary Control Council for Interference by

Information Technology Equipment (VCCI). If this equipment is used in a domestic environment,

radio disturbance may arise. When such trouble occurs, the user may be required to take corrective

actions.

Safety Information: Class 1 Laser Transceivers

Internet Appliance 1100/1200 Getting Started Guide v

Safety Information: Class 1 Laser Transceivers

This product may use Class 1 laser transceivers. Read the following safety information before

installing or operating this product.

The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation limits. This

control loop eliminates the need for maintenance checks or adjustments. The output is factory set and

does not allow any user adjustment. Class 1 laser transceivers comply with the following safety

standards:

• 21 CFR 1040.10 and 1040.11, U.S. Department of Health and Human Services (FDA)

• IEC Publication 825 (International Electrotechnical Commission)

• CENELEC EN 60825 (European Committee for Electrotechnical Standardization)

When operating within their performance limitations, laser transceiver output meets the Class 1

accessible emission limit of all three standards. Class 1 levels of laser radiation are not considered

hazardous.

Laser Radiation and Connectors

When the connector is in place, all laser radiation remains within the fiber. The maximum amount of

radiant power exiting the fiber (under normal conditions) is –12.6 dBm or 55 x 10

-6

watts.

Removing the optical connector from the transceiver allows laser radiation to emit directly from the

optical port. The maximum radiance from the optical port (under worst case conditions) is 0.8 W cm

-2

or 8 x 10

3

W m

2

sr–1.

Do not use optical instruments to view the laser output. The use of optical instruments to view

laser output increases eye hazard. When viewing the output optical port, power must be removed

from the network adapter.

Cabletron Systems, Inc. Program License Agreement

vi Internet Appliance 1100/1200 Getting Started Guide

Cabletron Systems, Inc.

Program License Agreement

IMPORTANT: THIS LICENSE APPLIES FOR USE OF PRODUCT IN THE FOLLOWING

GEOGRAPHICAL REGIONS:

CANADA

MEXICO

CENTRAL AMERICA

SOUTH AMERICA

BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT, CAREFULLY READ THIS

LICENSE AGREEMENT.

This document is an agreement (“Agreement”) between You, the end user, and Cabletron Systems, Inc.

(“Cabletron”) that sets forth your rights and obligations with respect to the Cabletron software

program (“Program”) in the package. The Program may be contained in firmware, chips or other

media. UTILIZING THE ENCLOSED PRODUCT, YOU ARE AGREEING TO BECOME BOUND BY

THE TERMS OF THIS AGREEMENT, WHICH INCLUDES THE LICENSE AND THE LIMITATION

OF WARRANTY AND DISCLAIMER OF LIABILITY. IF YOU DO NOT AGREE TO THE TERMS OF

THIS AGREEMENT, RETURN THE UNOPENED PRODUCT TO CABLETRON OR YOUR DEALER,

IF ANY, WITHIN TEN (10) DAYS FOLLOWING THE DATE OF RECEIPT FOR A FULL REFUND.

IF YOU HAVE ANY QUESTIONS ABOUT THIS AGREEMENT, CONTACT CABLETRON SYSTEMS

(603) 332-9400. Attn: Legal Department.

1. LICENSE. You have the right to use only the one (1) copy of the Program provided in this

package subject to the terms and conditions of this License Agreement.

You may not copy, reproduce or transmit any part of the Program except as permitted by the

Copyright Act of the United States or as authorized in writing by Cabletron.

2. OTHER RESTRICTIONS. You may not reverse engineer, decompile, or disassemble the

Program.

3. APPLICABLE LAW. This License Agreement shall be interpreted and governed under the laws

and in the state and federal courts of New Hampshire. You accept the personal jurisdiction and

venue of the New Hampshire courts.

4. EXPORT REQUIREMENTS. You understand that Cabletron and its Affiliates are subject to

regulation by agencies of the U.S. Government, including the U.S. Department of Commerce,

which prohibit export or diversion of certain technical products to certain countries, unless a

license to export the product is obtained from the U.S. Government or an exception from obtaining

such license may be relied upon by the exporting party.

If the Program is exported from the United States pursuant to the License Exception CIV under the

U.S. Export Administration Regulations, You agree that You are a civil end user of the Program and

agree that You will use the Program for civil end uses only and not for military purposes.

If the Program is exported from the United States pursuant to the License Exception TSR under the

U.S. Export Administration Regulations, in addition to the restriction on transfer set forth in

Cabletron Systems, Inc. Program License Agreement

Internet Appliance 1100/1200 Getting Started Guide vii

Sections 1 or 2 of this Agreement, You agree not to (i) reexport or release the Program, the source

code for the Program or technology to a national of a country in Country Groups D:1 or E:2

(Albania, Armenia, Azerbaijan, Belarus, Bulgaria, Cambodia, Cuba, Estonia, Georgia, Iraq,

Kazakhstan, Kyrgyzstan, Laos, Latvia, Libya, Lithuania, Moldova, North Korea, the People’s

Republic of China, Romania, Russia, Rwanda, Tajikistan, Turkmenistan, Ukraine, Uzbekistan,

Vietnam, or such other countries as may be designated by the United States Government), (ii)

export to Country Groups D:1 or E:2 (as defined herein) the direct product of the Program or the

technology, if such foreign produced direct product is subject to national security controls as

identified on the U.S. Commerce Control List, or (iii) if the direct product of the technology is a

complete plant o r any major component of a plant, export to Country Groups D:1 or E:2 the direct

product of the plant or a major component thereof, if such foreign produced direct product is

subject to national security controls as identified on the U.S. Commerce Control List or is subject to

State Department controls under the U.S. Munitions List.

5. UNITED STATES GOVERNMENT RESTRICTED RIGHTS. The enclosed Product (i) was

developed solely at private expense; (ii) contains “restricted computer software” submitted with

restricted rights in accordance with section 52.227-19 (a) through (d) of the Commercial Computer

Software-Restricted Rights Clause and its successors, and (iii) in all respects is proprietary data

belonging to Cabletron and/or its suppliers. For Department of Defense units, the Product is

considered commercial computer software in accordance with DFARS section 227.7202-3 and its

successors, and use, duplication, or disclosure by the Government is subject to restrictions set

forth herein.

6. EXCLUSION OF WARRANTY. Except as may be specifically provided by Cabletron in writing,

Cabletron makes no warranty, expressed or implied, concerning the Program (including its

documentation and media).

CABLETRON DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED TO YOU BY

CABLETRON IN WRITING, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED

TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR

PURPOSE, WITH RESPECT TO THE PROGRAM, THE ACCOMPANYING WRITTEN

MATERIALS, AND ANY ACCOMPANYING HARDWARE.

7. NO LIABILITY FOR CONSEQUENTIAL DAMAGES. IN NO EVENT SHALL CABLETRON OR

ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER (INCLUDING, WITHOUT

LIMITATION, DAMAGES FOR LOSS OF BUSINESS, PROFITS, BUSINESS INTERRUPTION,

LOSS OF BUSINESS INFORMATION, SPECIAL, INCIDENTAL, CONSEQUENTIAL, OR

RELIANCE DAMAGES, OR OTHER LOSS) ARISING OUT OF THE USE OR INABILITY TO USE

THIS CABLETRON PRODUCT, EVEN IF CABLETRON HAS BEEN ADVISED OF THE

POSSIBILITY OF SUCH DAMAGES. BECAUSE SOME STATES DO NOT ALLOW THE

EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL

DAMAGES, OR IN THE DURATION OR LIMITATION OF IMPLIED WARRANTIES IN SOME

INSTANCES, THE ABOVE LIMITATION AND EXCLUSIONS MAY NOT APPLY TO YOU.

Cabletron Systems Sales and Service, Inc. Program License Agreement

viii Internet Appliance 1100/1200 Getting Started Guide

Cabletron Systems Sales and Service, Inc.

Program License Agreement

IMPORTANT: THIS LICENSE APPLIES FOR USE OF PRODUCT IN THE UNITED STATES OF

AMERICA AND BY UNITED STATES OF AMERICA GOVERNMENT END USERS.

BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT, CAREFULLY READ THIS

LICENSE AGREEMENT.

This document is an agreement (“Agreement”) between You, the end user, and Cabletron Systems

Sales and Service, Inc. (“Cabletron”) that sets forth your rights and obligations with respect to the

Cabletron software program (“Program”) in the package. The Program may be contained in firmware,

chips or other media. UTILIZING THE ENCLOSED PRODUCT, YOU ARE AGREEING TO BECOME

BOUND BY THE TERMS OF THIS AGREEMENT, WHICH INCLUDES THE LICENSE AND THE

LIMITATION OF WARRANTY AND DISCLAIMER OF LIABILITY. IF YOU DO NOT AGREE TO THE

TERMS OF THIS AGREEMENT, RETURN THE UNOPENED PRODUCT TO CABLETRON OR YOUR

DEALER, IF ANY, WITHIN TEN (10) DAYS FOLLOWING THE DATE OF RECEIPT FOR A FULL

REFUND.