Philips HP4687 User manual

Page is loading ...

6

Introduction

Congratulations on your purchase and welcome to Philips! To fully benet

from the support that Philips offers, register your product at www.philips.

com/welcome.

The new Philips SalonStraight Glamour gives you the straightening result

you want, so you can look your best, everytime. The anodised titanium

plates are so hard that they are not affected by your styling products and

work with them to create a perfect straightening result.

General description (Fig. 1)

A Anodised titanium plates

B Temperature wheel

C Power-on light

D On/off switch

Important

Read this user manual carefully before you use the appliance and save it

for future reference.

Danger

Keep the appliance away from water. Do not use it near or over

water contained in baths, washbasins, sinks etc. When you use the

appliance in a bathroom, unplug it after use. The proximity of water

presents a risk, even when the appliance is switched off.

Warning

Check if the voltage indicated on the appliance corresponds to the

local mains voltage before you connect the appliance.

Check the condition of the mains cord regularly. Do not use the

appliance if the plug, the mains cord or the appliance itself is damaged.

If the mains cord is damaged, you must have it replaced by Philips, a

service centre authorised by Philips or similarly qualied persons in

order to avoid a hazard.

This appliance is not intended for use by persons (including children)

with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision

-

ENGLISH

or instruction concerning use of the appliance by a person

responsible for their safety.

Children should be supervised to ensure that they do not play with

the appliance.

Keep the appliance away from non-heat-resistant surfaces and never

cover the appliance with anything (e.g. a towel or clothing) when it is

hot.

Keep the appliance away from ammable items.

Never leave the appliance unattended when it is connected to the

mains.

Caution

For additional protection, we advise you to install a residual current

device (RCD) in the electrical circuit that supplies the bathroom. This

RCD must have a rated residual operating current not higher than

30mA. Ask your installer for advice.

The straightening plates and the plastic parts near the plates reach a

high temperature quickly. Prevent the hot surfaces of the appliance

from coming into contact with your skin.

The maximum temperature occurs just after heating up. The actual

temperature during use may be lower.

Always unplug the appliance after use.

Wait until the appliance has cooled down before you store it.

Always switch off the appliance before you put it down, even if it is

only for a moment.

Do not wind the mains cord round the appliance.

Only use the appliance on dry hair.

Do not use the appliance on articial hair.

Do not use the appliance for any other purpose than described in

this manual.

Do not leave the plates in your hair for more than a few seconds at a

time as this may cause damage to your hair.

Keep the straightening plates clean and free of dust and dirt for a

perfect straightening result.

If you use the appliance on colour-treated hair, the straightening plates

may stain.

-

ENGLISH 7



This Philips appliance complies with all standards regarding

electromagnetic elds (EMF). If handled properly and according to the

instructions in this user manual, the appliance is safe to use based on

scientic evidence available today.

Using the appliance

Straighteners are powerful styling tools and must always be used with

care.

As with all straighteners that reach salon-high temperatures, do not use

the appliance frequently to avoid damage to the hair. If you use the

straightener incorrectly or if you use it at the wrong temperature setting,

you could overheat your hair or even burn it. Always make sure you

select a temperature setting that is suitable for your hair type.

Straightening

1 Put the plug in the wall socket.

2 Set the on/off switch to ‘I’.

The blue power-on light goes on.

Never leave the appliance unattended when it is plugged in. Always put

the appliance on a heat-resistant surface when it is heating up and

when it is hot.

3 Turn the temperature wheel to select the required temperature

setting. Select a temperature setting that is suitable for your

hair. (Fig. 2)

Always select a low setting when you use the straightener for the rst

time.

For coarse, curly or hard-to-straighten hair, select a medium to high

setting.

For ne, medium-textured or softly waved hair, select a medium to

low setting.

Take extra care with pale, blonde, bleached or colour-treated hair, since

it is susceptible to damage at high temperatures.

,

-

ENGLISH8

4 Turn the temperature wheel to set the temperature.

5 Let the appliance heat up for at least 30 seconds.

6 Comb or brush your hair so that it is disentangled and

smooth. (Fig. 3)

Use a comb to divide the hair into sections. Do not put too much hair in

one section.

Note: It is better to section off the crown area and to straighten the hair

underneath rst, followed by the top area.

7 Take a section that is not wider than 5cm. Place it between the

straightening plates and press the handles of the appliance rmly

together.

8 Slide the straightener down the length of the hair in 5 seconds,

from root to hair end, without stopping to prevent

overheating (Fig. 4).

9 Repeat this process after 20 seconds until you have achieved the

desired look.

10 Let your hair cool down. Do not comb or brush it before it has

cooled down, as this would ruin the hairstyle you have just created.

Cleaning

Never immerse the appliance in water or any other liquid, nor rinse it

under the tap.

1 Switch off the appliance and unplug it.

2 Let the appliance cool down completely on a heat-resistant surface.

3 Clean the appliance with a damp cloth.

Storage

Never wind the mains cord round the appliance.

ENGLISH 9

1 Switch off the appliance and unplug it.

2 Let the appliance cool down completely on a heat-resistant surface.

3 Store the appliance in a safe and dry place.

Environment

Do not throw away the appliance with the normal household waste

at the end of its life, but hand it in at an ofcial collection point for

recycling. By doing this, you help to preserve the environment (Fig. 5).

Guarantee & service

If you need service or information or if you have a problem, please visit

the Philips website at www.philips.com or contact the Philips Consumer

Care Centre in your country (you nd its phone number in the

worldwide guarantee leaet). If there is no Consumer Care Centre in

your country, go to your local Philips dealer.

Troubleshooting

This chapter summarises the most common problems you could

encounter with the appliance. If you are unable to solve the problem with

the information below, contact the Philips Consumer Care Centre in your

country.

Problem Possible cause Solution

The

appliance

does not

work.

There is a power

failure or the

socket to which

the appliance is

connected is not

live.

Check if the power supply works. If

it does, plug in another appliance to

check whether the socket is live.

-

ENGLISH10

Problem Possible cause Solution

The mains cord is

damaged

If the mains cord is damaged, you

must have it replaced by Philips, a

service centre authorised by Philips

or similarly qualied persons in

order to avoid a hazard.

ENGLISH 11

Page is loading ...

www.philips.com

u

4222.002.7116.2

Philips HP4687 User manual

This manual is also suitable for

Philips HP4687 User manual

in other languages

Related papers

Other documents