Remington Code XT-100 User manual

®

MC

Use and

Care Guide

XT-100

Use and

Care Guide



33236_XT-100_IB-Revised.indd 1 2/1/07 3:04:23 PM

3

When using an electrical appliance,

basic precautions should always be

observed, including the following.

Read all instructions before using this

appliance.

DANGER

To reduce the risk of electric shock:

■ Do not reach for an appliance that

has fallen into water. Unplug it

immediately.

■ Do not place or store this appliance

where it can fall or be pulled into

a tub or sink while it is plugged in.

Do not place in or drop into water

or other liquid.

■ Except when charging, always

unplug this appliance from the

electrical outlet immediately

after using.

■ Unplug this appliance before

cleaning it.

■ Do not use an extension cord or

a voltage converter with this

appliance.

■ Do not use while bathing or in

the shower.

■ Do not use outdoors or operate

where aerosol (spray) products are

being used, or where oxygen is

being administered.

■ Always store this appliance and

cord in a moisture-free area.

Do not store it in temperatures

exceeding 140°F (60°C).

■ Do not plug or unplug this

appliance when your hands are

wet.

■ Shavers, including the trimmer, are

for use on facial hair only. Shaver

should not be used for shaving the

hair on your head or any other part

of your body.

SAVE THESE INSTRUCTIONS

■ Do not wrap the cord around the

appliance.

■ Always attach the plug to the

appliance, then to the outlet. To

disconnect, turn all controls to

OFF, then remove plug from outlet.

Detach removable power cords

from appliances for storage.

■ Do not use this appliance with

a damaged or broken screen or

cutters, as injury may occur.

■ The power unit is intended to be

correctly oriented in a vertical or

floor mount position.

WARNING

To reduce the risk of burns, fire,

electric shock or injury to persons:

■ This appliance is for household

use only.

■ An appliance should never be left

unattended when it’s plugged

in, except when charging a

rechargeable appliance.

■ Close supervision is necessary

when this appliance is used by, on,

or near children or invalids.

■ Use this appliance only for its

intended use as is described in this

manual. Do not use attachments

not recommended by Spectrum

Brands, Inc.

■ Keep the cord away from heated

surfaces.

■ Never operate this appliance if it

has a damaged cord or plug, if it

is not working properly, if it has

been dropped or damaged, or if it

has been dropped into water. If any

of these things happen, return the

appliance to an authorized service

center for examination and repair.

■ Never drop or insert any object into

any of the appliance’s openings.

IMPORTANT SAFETY

INSTRUCTIONS

2

Contents

English ......................1

Spanish ...................13

French .....................25

33236_XT-100_IB-Revised.indd 2-3 2/1/07 3:04:23 PM

Shaver Parts

(A) Head & cutter assembly

(B) Foil Screen

(C) ON/OFF button

(D) Charging Indicator

(E) Head release button

(F) Power Adapter

(G) Headguard

(H) Cleaning brush

(I) Comfort Guard

(J) Low Battery Indicator

4

Product Features

5

(B)

(I)

(G)

(A)

(H)

Removing the Headguard

Before operating your shaver, remove

the Headguard, which protects

the Foils and Cutter Assembly. It is

important to remove the Headguard

correctly to avoid damaging the clips

that hold it firmly to the shaver.

1. Press lightly on the top of the

headguard.

2. Lift the lower rear edge.

3. Pull the Headguard away from

the shaver.

Operation

Use of this shaver at voltages other

than the ones specified below will

cause damage and will void the war-

ranty. Model XT-100 uses 105-130

VAC, 60 Hz.

Charging

Before using your shaver for the first

time, put it on charge for 24 hours.

NOTE: It may take up to 3 cycles for

the battery to reach full capacity.

To charge your shaver:

■ Slide the power button to the

OFF position.

■ Connect the supplied power

adapter to the shaver’s cord socket

and then to an electrical outlet.

■ Your shaver cannot be overcharged,

so you can leave it plugged in and

charging between shaves.

■ To preserve the life of the batteries,

allow them to fully discharge every

six months, then recharge them for

24 hours.

NOTE: LEDs illuminate behind the

green lens when the shaver is

charging.

To Shave

With the shaver unplugged, slide the

ON/OFF button upward to turn on.

Note that this shaver is designed

only to operate on power from its

batteries; it must be charged before

using.

Comfort Guard

■ The comfort guard lever can be

kept in the down position while

shaving to expose the entire

trimmer.

■ To avoid irritating sensitive areas

of the face and neck, raise the

comfort guard and shave normally.

The guard will allow hair to pass

through and be cut, but will keep

the trimmer away from the skin.

■ To trim facial hair, simply lower the

comfort guard.

(J)

(E)

(D)

(F)

(C)

33236_XT-100_IB-Revised.indd 4-5 2/1/07 3:04:30 PM

Getting Used To Your Shaver

As with every shaver, your shave will

improve over time. Allow about three

weeks to develop an effective shav-

ing style and for your skin to adjust

to the new shaver. The adaptation

period may take a little longer if your

skin is sensitive, if you are switch-

ing from a different way of shaving,

or if you alternate between shaving

methods.

When you first removed your shaver

from its box, you may have noticed

what appear to be small particles

of white or gray power on the foil

in or around the cutter assembly.

The particles are from a coating of a

special lubricant applied to the new

foil and cutters to smooth breaking

in your new shaver. They will disap-

pear with use.

To shave

Slide the ON/OFF button upwards.

Hold the shaver so the foil is

perpendicular to your face. This

allows the shaver to work the way it

was designed for the closest shave

and minimum wear. Avoid holding

the shaver at an angle. This will

distort the screen and could cause

skin irritation.

NOTE: This shaver is designed only

to operate from it’s batteries: it must

be charged before using.

Shave with short, circular strokes.

Use your free hand to stretch your

skin. This encourages your whiskers

to stand out, making it easier for

them to enter the cutting chamber.

Never press hard. Pressing only flat-

tens your whiskers, making it harder

for them to enter the cutting cham-

ber. It will also wear out the cutting

surface more quickly.

7

6

How To Use

Before you begin:

■ Wait at least 15

minutes after

getting up before

shaving, to ensure

the face is free of

puffiness that may be present from

sleeping.

■ Make sure your

face is clean and

dry before starting.

■ Always use a clean,

dry shaver.

6

12

9

3

33236_XT-100_IB-Revised.indd 6-7 2/1/07 3:04:31 PM

Cleaning Your Shaver

To assure smooth, efficient perfor-

mance, it is important to clean your

shaver. Cleaning your Remington

®

Shaver is easy.

1. Remove the Head

Assembly by holding

onto the sides of the

Head Assembly at

the arrows, press

the two head release

buttons while gently

lifting the assembly

away from the shaver.

2. Tap the base of the Head Assembly

lightly on a flat surface. This

should dislodge most of the hairs

trapped within it. To guard against

inadvertent damage, do not

remove the Foil Assembly.

3. Next, clean the

Cutter Assembly

while it is still on

the shaver. Hold the

shaver and Cutter

Assembly as shown,

and using the brush

supplied, lightly brush and blow

the hair clippings from between

the blades.

Tip: To help reduce wear and tear,

spray the Head Assembly with

Remington

®

Spray Shaver-Saver

®

Lubricant after every shave. This

helps remove hairs while keeping

your shaver operating smoothly.

8

9

Cleaning & Maintenance

Cleaning Cautions

■ Do not use an aggressive cleansing

agent as this may destroy the

shaver coatings.

■ Do not remove or replace the head

assembly while shaver is running

as it may cause damage to the

unit's screen or cutter.

Trimmer Care

Cleaning

■ When you clean your shaver, just

brush off any clippings that may

accumulate around the trimmer

assembly.

■ Every six months apply a drop

of light machine oil one-third

and two-thirds of the way along

the blade.

■ Using your fingertip, spread the oil

along the teeth.

■ Run the trimmer for a few

seconds to distribute oil.

33236_XT-100_IB-Revised.indd 8-9 2/1/07 3:04:54 PM

KEEP ORIGINAL SALES RECEIPT

AS PROOF OF PURCHASE FOR

WARRANTY PURPOSES.

This warranty does not cover prod-

ucts damaged by the following:

■ Accident, misuse, abuse or

alteration of the product

■ Servicing by unauthorized persons

■ Use with unauthorized accessories

■ Connecting it to incorrect current

and voltage

■ Wrapping cord around appliance

causing premature wear and

breakage

■ Any other conditions beyond our

control

11

10

Battery Disposal

Battery Removal

When your recharge-

able shaver reaches

the end of its useful

life, the batteries

must be removed from the shaver

and be recycled or disposed of

properly in accordance with your

state and local requirements. If this

is not required by law, you may elect

to dispose of the shaver without

removing the batteries.

CAUTION: DO NOT PUT IN FIRE OR

MUTILATE YOUR BATTERIES WHEN

DISPOSING AS THEY MAY BURST

OR RELEASE TOXIC MATERIALS.

DO NOT SHORT CIRCUIT AS IT MAY

CAUSE BURNS. DISPOSE PROPERLY

IN ACCORDANCE WITH YOUR LOCAL

AND STATE REQUIREMENTS.

Performance Guarantee

Full Two-Year Warranty

Spectrum Brands, Inc. warrants this

product against any defects that are

due to faulty material or workman-

ship for a two-year period from the

original date of consumer purchase.

This warranty does not include dam-

age to the product resulting from

accident or misuse.

If the product should become defec-

tive within the warranty period, we

will repair it or elect to replace it

free of charge. Return your product

and sales receipt with your name,

address and day time phone number

to: Spectrum Brands, Inc., Attention:

Consumer Services, 601 Rayovac

Drive, Madison, WI 53711. For more

information call 800-736-4648 in the

US or 800-268-0425 in Canada.

Warranty excludes:

■ Screen and cutter

The following procedure should be

followed for battery removal:

■ To avoid possible electric shock

hazard, unplug cord form electrical

outlet and shaver.

■ Remove the Head Assembly by

pushing in on the Head Assembly

release buttons.

■ Remove the two screws on the

upper back side of the shaver.

■ Pry the lower lens from the shaver

body to expose the third screw.

■ Remove the screw.

■ Pull or pry the shaver halves apart.

■ Pull out the batteries.

■ Clip the wire connections between

the circuit board and batteries.

CAUTION: THESE NICKEL-CADMIUM

BATTERIES MUST BE RECYCLED OR

DISPOSED IN ACCORDANCE WITH

STATE AND LOCAL REGULATIONS.

Do not burn or mutilate, as they may

burst or release toxic materials. Do not

short-circuit, as it may cause burns.

BATTERY MUST BE RECYCLED

OR DISPOSED OF PROPERLY.

Ni-Cd

CONTAINS NICKEL-

CADMIUM BATTERY.

33236_XT-100_IB-Revised.indd 10-11 2/1/07 3:04:55 PM

®

MC

SPECTRUM BRANDS, INC. SHALL

NOT BE RESPONSIBLE FOR

ANY INCIDENTAL, SPECIAL OR

CONSEQUENTIAL DAMAGES

RESULTING FROM THE USE OF THIS

PRODUCT. ALL IMPLIED WARRANTIES,

INCLUDING BUT NOT LIMITED TO

IM PLIED WARRANTIES OF FITNESS

AND MERCHANTABILITY, ARE LIMITED

IN DURATION TO TWO YEARS FROM

DATE OF ORIGINAL PURCHASE.

This warranty gives you specific legal

rights and you may also have other

rights which vary from state to state

or province to province. Some states

do not allow the exclusion or limita-

tion of incidental, special or conse-

quential damages.

Performance Guarantee

Spectrum Brands, Inc. Money-back

Offer

If within 30 days after you have

purchased your Remington

®

branded

product, you are not satisfied and

would like a refund, return it with

the sales slip indicating purchase

price and date of purchase to the

retailer from whom it was purchased.

Spectrum Brands, Inc. will reimburse

all retailers who accept the product

within 30 days from the date of pur-

chase. If you have any questions con-

cerning the money-back guarantee,

please call 800-736-4648 in the US

or 800-268-0425 in Canada.

105-130 VAC 60 Hz

Questions or comments:

Call 800-736-4648 in the US or

800-268-0425 in Canada. Or visit

www.remington-products.com

Dist. by: Spectrum Brands, Inc.,

Madison, WI 53711

Dist. by: Spectrum Brands Canada

Inc., Brantford, ON N3V 1E8

® Registered trademark and TM

Trademark of Spectrum Brands, Inc.,

or one of its subsidiaries.

01/07 Job #CS33236

MADE IN CHINA

Performance Guarantee

T22-24605

Guia para

el Uso y el

Cuidado

XT-100



Guia para

el Uso y el

Cuidado

33236_XT-100_IB-Revised.indd 12-13 2/1/07 3:04:57 PM

Page is loading ...

Remington Code XT-100 User manual

This manual is also suitable for

Remington Code XT-100 User manual

in other languages

Related papers

Other documents