Instruction ManualGB
5
Don’t worry if the indicator light comes on
briefly. It could be due to warm food storage
or warm air in the freezer compartment or if
freezer door has been left open for long periods.
Economic usage indicator light
It becomes active when freezer temperature is
set to –18° and fridge temperature is set to 8°C
at the same time. It means economic usage.
Self-diagnostic
Your appliance incorporates a self-diagnostic
system. Certain characters (E0, E3, etc.) will
be displayed where the freezer temperature is
usually shown. During this time “!” light will
flash on the display. Please first see “trouble
shooting” section and then “Service” section
for further information.
Before operating
Final Check
Before you start using the appliance check that:
1. The feet have been adjusted for perfect
leveling.
2. The interior is dry and air can circulate freely
at the rear.
3. The interior is clean as recommended under
"Cleaning and care.”
4. The plug has been inserted into the wall
socket and the electricity is switched on. When
the door is open the interior light will come on.
And note that:
5. You will hear a noise as the compressor
starts up. The liquid and gases sealed within
the refrigeration system may also make some
(noise), whether the compressor is running or
not. This is quite normal.
6. Slight undulation of the top of the cabinet
is quite normal due to the manufacturing process
used; it is not a defect.
7. We recommend setting the thermostat knob
midway and monitor the temperature to ensure
the appliance maintains desired storage
temperatures (See section Temperature Control
and Adjustment).
8. Do not load the appliance immediately it is
switched on. Wait until the correct storage
temperature has been reached. We recommend
checking the temperature with an accurate
thermometer (see; Temperature Control and
Adjustment).
Important: When you change the set
temperature, wait approximately 8 hours to
allow the appliance to reach and maintain the
new setting. Actual temperature of the cabinets
can fluctuate after opening the doors or storing
hot food inside the cabinet.
Door open alarm
If the fridge door left open for longer than 1
minute, an audible alarm will sound to alert
you to close the door as soon as possible. To
switch it off close the door or press any button
on the display.
Quick freeze function
The quick-freeze function enables you to load
frozen food to be frozen in freezer compartment.
Press quick-freeze button when you place food
in the freezer compartment for the first time.
Freezer set temperature will display –27°C and
quick-freeze function light on. Quick freeze
function lasts for maximum 12 hours. When
the quick-freeze function is completed, light will
be automatically off and original setting will
take place. If you want to cancel the function
before the time is completed, press quick-freeze
button once.
The electronic control system incorporates a
safety protection so that if the quick-freeze
function button pressed more than once, the
compressor will not come on. Wait for about
6 minutes and try again.
Quick fridge function
This button is designed for fast cooling of fresh
food compartment of your appliance. Press
quick-fridge button to start the function, quick-
fridge light will be. Quick fridge function lasts
for maximum 3 hours. When the quick- fridge
function is completed, light will be automatically
off and original setting will take place. If you
want to cancel the function before the time is
completed, press quick- fridge button once.
The electronic control system incorporates a
safety protection so that if the quick- fridge
function button pressed more than once, the
compressor will not come on. Wait for about
6 minutes and try again.
High freezer temperature warning light
If the freezer temperature becomes too high,
then the warning indicator light will flash. If the
indicator remains on more than 12 hours,
please contact with your service agency.