2. Creative Playthings
  3. 50545-555
50545-555

Creative Playthings 50545-555 User manual

  • Hello! I am an AI chatbot trained to assist you with the Creative Playthings 50545-555 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What is the purpose of the Glider Bracket Pack?
    What components are included in the package?
    What swing beams are compatible with this package?
    Are there any particular safety measures to consider during installation?
    What is the significance of the special coating on the hardware?
    What should be done if non-Creative Playthings hardware is used?
    What are the steps involved in preparing for installation?
4 14186-400 GliderBracket
 
8 12002-207 FlatWasher,3/8"
4 12017-207 LockWasher,3/8"
4 17003-1413 HexBolt,3/8x3-1/2"
4 17003-1813 HexBolt,3/8x4-1/2"
4 12052-107 NylockNut,3/8"
8 12002-206 FlatWasher,5/16"
8 17036-602 LagScrew,5/16x1-1/2"











HexBolt3/8x4-1/2"
HexBolt3/8x3-1/2"
LagScrew5/16x1-1/2"
FlatWasher3/8"
LockNut3/8"LockWasher3/8"
FlatWasher5/16"

Ifthisisanewinstallation,donotinstallthepair
of Swing Hangers closest to the Legs of the
SwingBeam.IftheSwingHangersarealready
installed,removethem.
Find the two pair of Bolts above the Swing
Hanger positions nearest the Legs. Remove
thefourHexBoltsandassociatedwashersand
weldnuts.
Seeinstructionforthegym
towhichtheSwingBeamis
mountedforspecialsafety
informationregardingrequired
space,resilientgroundcover,
etc.
ThispackageisforusewithPremiumPineand
ClassicPineswingbeams.ThePremiumPine
beamisshownintheillustrations.
GliderBrackets
RemoveBolts

©Copyright2014,CreativePlaythings.PrintedinU.S.A.
19919-100RevA(09-14)
GliderBracketPack


Ononesideofthebeam,alignthetopholes
of a Glider Bracket with two of the holes
where Bolts were removed in the previous
step.Markthepositionofthelowerholesof
theGliderBracketontheBeam.Dothesame
withanotherGliderBracketandtheotherpair
ofholes.
Drill 3/16" diameter holes 1-1/2" into the
Beamatthemarks.
TurntheBeamover.Markanddrillthebeam
inthesamemanner.

FastentheGlidersBracketstotheBeamAs-
sembly using two 3/8 x 4-1/2" Hex Bolts*,
four3/8FlatWashers,andtwoNylockNuts
foreachpairofBrackets,intheupperholes
asshown.Useone5/16x1-1/2"LagScrew
with one 5/16 Flat Washer for each of the
eightremaininglowerholes.
*Use3/8x3-1/2"BoltsfortheClassicPine
Beam.

HangtheBack-to-BackGliderbyhookingthe
chaininthesnaphooksontheGliderHang-
ers.Followthespecialassemblyinstructions
includedfortheBack-to-BackGlider.
U.S. safety standards require a minimum
clearance of 8" from the bottom of each
SwingAccessorytotheground.U.K.(&E.U.)
safety standards require a minimum clear-
anceof350mm(13-3/4")betweenthebottom
ofeachSwingAccessoryandtheground.
The height of each SwingAccessory is ad-
justed byusing a different linkin the chain.
BesuretohangtheSwingsAccessorieswith
groundclearancegreaterthanorequaltothe
safetystandardforyourregion.
Drill3/16"
Dia.Holes
/