2. CTI
  3. SL-120 stacklight

CTI SL-120 stacklight Operating instructions

  • Hello! I have reviewed the instructions for the SL-120 series stacklights. This document details the wiring for each of the stacklight modules (1-5), as well as instructions for mounting the device using either the panel-mount or pole-mount adaptors. I'm ready to answer your questions regarding this product.
  • What does the 'C' terminal refer to?
    How are the modules assembled?
    What are the two mounting adaptors included with each base?
920 North Tradewinds Pkwy
Columbia, MO 65201
[email protected]
866-394-5861
SL-120-DOC1-0
SL-120 Series Stacklights
Wiring Instructions
These stacklight modules are twist-lock assembled. Remove the bottom base
module and unsnap the wire terminal to access it.
“C” terminal is Common to all connected modules.
Numbers 1 through 5 refer to the modules,
in order from the base to the top.
C = Common (Neutral)
1 = 120VAC for rst module
2 = 120VAC for second module
3 = 120VAC for third module
4 = 120VAC for fourth module
5 = 120VAC for fth module
Mounting Instructions
Two mounting adaptors are included with each base.
For panel-mount installation: Use the black anodized tting.
1. Slide the unthreaded end securely into the bottom of the
base module.
2. Tighten the binding screw on the inside of the base to
secure it in place.
3. Use the two included nuts to hold stacklight in place on a
panel or conduit box.
For pole-mount installation: Use the compression tting.
1. Screw the ½” NPT threads of the compression tting
rmly into the bottom of the base module. The base is
not threaded but the tting will “cut” threads, holding it
rmly in place. A watertight seal can be made with the
use of a silicone adhesive or other sealant.
2. The assembled unit can now be installed onto ½” EMT
conduit.
For additional help with this product, call CTI at 866-394-5861
during normal business hours.
/