Vesta VRH-ARLINGTON-30SS Arlington 850CFM 30 Inch Stainless Steel Under Cabinet User manual

ARLINGTON

User Manual

VRH-ARLINGTON-30SS

1

4

5

6

7

18

19

20

23

24

Table of Contents

Warning

Tools Needed

Parts & Accessor ies

Product Dimension

Installation

Operations

Maintenance

Warranty

Disclaimer

Contact Us

Warning

1. Installation work and electric wiring (including switch

location) must be done by the qualiﬁed person(s) in

accordance with local applicable codes and standards,

including ﬁre-rated construction.

2. This hood may have sharp edges. Be careful to avoid cuts

and abrasions during installation and cleaning.

3. The hood must be placed at a minimum distance of 60cm

from the cook panel.

4. Suﬃcient air is needed for proper combustion and exhausting

of gases through the chimney of fuel burning equipment

to prevent back drafting. Follow the heating equipment

manufacturer’s guideline and safety standards such as

those published by the National Fire Protection Association,

and the American Society for Heating, Refrigeration and

Air Conditioning Engineer (ASHRAE), and the local code

authorities.

5. Ducted fans must always be vented to the outdoors.

6. This appliance is designed to be operated by adults. Children

were not allowed to temper with the controls or play with this

appliance.

7. WARNING: To reduce the risk of ﬁre or electric shock, do not

use this fan with any solid-state speed control device.

8. When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

WARNING – TO REDUCE THE RISK OF FIRE, USE ONLY THE METAL

DUCTWORK

1

WARNING – TO REDUCE THE RISK OF INJURY TO PERSONS IN THE

EVENT OF A RANGE TOP FIRE, OBSERVE THE FOLLOWING

1. SMOTHER FLAMES with a close-ﬁtting lid, cookie sheet or metal

tray, then turn o ﬀthe burner, BE CAREFUL TO PREVENT BURNS.

If the ﬂames do not go out immediately, EVACUATE AND CALL

THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN – You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels – a

violent steam explosive will result

4. Use an extinguisher ONLY if:

• You know you have a Class ABC extinguisher, and you

already know how to operate it;

• The ﬁre is small and contained in the area where it

started;

• The ﬁre department is being called;

• You can ﬁght the ﬁre with your back to an exit.

WARNING – TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

1. Never leave surface units unattended at high settings. Boil

overs cause smoking and greasy spillovers that may ignite.

Heat oils slowly on low or medium settings.

2. Always turn hood ON when cooking at high heat or when

ﬂambéing food.

3. Clean ventilating fans frequently. Grease should not be

allowed to accumulate on fan or ﬁlter.

2

4. Use proper pan size. Always use cookware appropriate for the

size of the element.

WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSON, KEEP IN MIND THE FOLLOWING:

1. Use this unit only in the manner intended by the

manufacturer. If you have questions, contact the

manufacturer.

2. Before servicing or cleaning unit, switch power o ﬀat service

panel and lock the service disconnecting means to prevent

power from being switch on accidently. When service

disconnecting means cannot be locked, securely fasten

a prominent warning device, such as a tag, to the service

panel.

3

4

Tools Needed

1/4”

Screws for install

×4

Gasket

×4

Air outlet

×1

5

Parts & Accessories

×3

×1

Range Hood

Oil Tray

Wire Connect or Screws for air outlet Rubber Ring

×3 ×1

Rubber

x 2

755mm(29.7inchs)

158mm(6.2inchs)

40mm(1.6inchs)

560mm(22inchs)

315mm(12.4inchs)

∅

150mm(6inchs)

120 60

6

Product Dimension

560(22")

158mm(6.2")

32Wx2

755mm(29.7'')

850 430

7

Installation

8

Switching to Top Round Vent Adapter

There are 2 perforated circles at the back and top corner.

Based on the location of your wires, punch through the

circle that is the closest to your wire location.

9

Also apply two rubbers on the back.

Snap on the rubber ring

10

Feed the wires through the hole

11

12

13

Connect round vent to vent adapter.

Seal with aluminum foil tape.

14

15

Connect the wires:

• Black to Hot line

• White to Neutral line

• Green to Ground line

• Secure with “Twist-on Caps”

16

17

Setting the timer delay:

Setting the light intensity level:

18

Operations

Introduction Of Control Panel

The hood is operated using 3 speeds soft touch control on the

front panel.

Setting the speed:

The speed option is easy to set by touching control panel

If want low speed you can touch

and is the mid speed and is high speed

This range hood oﬀers an upgraded illumination mechanism

and has two light intensity levels. By touching the light button

, a low intensity is set. If you touch the button

again, higher light intensity is set. By touching the button third

time, the light will turn oﬀ.

While the range hood is running, touch to

initiate the time delay

Page is loading ...

Vesta VRH-ARLINGTON-30SS Arlington 850CFM 30 Inch Stainless Steel Under Cabinet User manual

Vesta VRH-ARLINGTON-30SS Arlington 850CFM 30 Inch Stainless Steel Under Cabinet User manual

Related papers

Other documents